Gainsborough BERENO User manual

Bereno IFU v1.2 1
Gainsborough Bathrooms Ltd
Gainsborough House
Brickyard Road
Aldridge WS9 8SR
United Kingdom
Tel: [phone]
email: [email protected]
www.gainsboroughbaths.com
BERENO
USER MANUAL

Bereno IFU v1.2 2
OPERATING INSTRUCTIONS
Your bath is simple to use and maintain. However, there are some basic guidelines which
should be followed to ensure you get the best out of your unit.
Please ensure that hands and objects are kept away from the underside of the seat when
lowering into the bath.
To clean the unit, hot soapy water should be sufficient. Scouring powder and abrasive
cleaners must never be used.
To operate the unit, please follow these simple instructions:-
The push buttons used to operate the bath seat are completely safe to use with wet hands.
The bath seat should be lifted from its parked position in the base of the bath using the up
button. Once the seat is up it is recommended that you enter the bath and close the door.
Make yourself comfortable on the seat and commence filling the bath with water. Please
note that the bath should not be filled to its maximum capacity, as when the user enters
the bath, the water level will rise.
In the event of the bath being overfilled, water may either drain naturally through the
overflow, or the plug should be temporarily removed to allow a sufficient amount of water
to be drained away. Once the bath has been filled, the seat should then be lowered to the
base of the bath.
Once you have finished bathing it may be emptied in the conventional manner.
The door must not be opened until the bath is completely empty of water.
Removing the Seat
To remove the seat, simply depress the two buttons located on the top of the yoke
simultaneously, and at the same time lift the seat.
HELPFUL HINTS
Make sure the bathroom is warm before you decide to have your bath. In this way you will
be able to enjoy your bath fully.
A small towel draped across the shoulders whilst the bath is filling is also a good way to
ensure you are fully relaxed.
We suggest that, as the bath is filling, you wash yourself working from the toes upwards so
that as the water rises you are rinsed off automatically!
Keep a towel handy so that you can dry yourself as the bath empties.

Bereno IFU v1.2 3
Care
The bath should be wiped down, preferably whilst the bath is draining, with a soft, damp
soapy cloth. On no account should abrasive cleaners or bleaches be used.
Particular attention should be paid to the cleaning of the door seal, as the slightest amount
of debris can cause the seal to leak.
Plated fittings, such as the handle and hinges, must only be wiped with a soft, damp soapy
cloth.
A weekly wipe around the seal with a soft, damp soapy cloth is recommended to ensure it
remains serviceable.
Chalk mark deposits from the water or mild scratches may be removed from the bath
surface with a mild cutting fluid such as 'T' Cut or Brasso. This should be applied to the
affected area with a soft cloth and rubbed vigorously until a satisfactory finish is effected.
The shine to the area may then be brought back using a wax-based polish.
The shafts connecting the seat to the bath should be cleaned weekly using a silicone-
based furniture polish. (i.e. Mr. Sheen). Please do not use wax-based products. When
not in use, the seat should be left in the down position inside the bath.
IMPORTANT
When not in use the door should be left in the closed position, although not in the fully
latched closed position. This will prevent the hinges being strained whilst stopping the
seal becoming compressed over time.
ON NO ACCOUNT SHOULD PRESSURE BE PUT ON THE DOOR WHILST IN THE
OPEN POSITION
PLEASE NOTE THERE ARE NO USER SERVICEABLE ITEMS ON THIS UNIT
[email protected]