Gallagher SmartReader 3E0740 User manual

3E0740 SmartReader Extension Mounting Kit Installation
Page 1
SmartReader Extension Mounting
Kit installation
The Extension Mounting Kit contains:
1 x Extension cable (4m)
1 x Mounting bracket
2 x metal tek screws
Mount the Antenna Panel
Mount the Antenna Panel as per your SmartReader manual.
Mounting the Electronic Controller
Considerations
The Extension cable is part of the Antenna Panel circuit so keep
away from large metal surfaces.
Ensure the Electronic Controller mounting location provides
protection from being knocked or damaged by animals.
Ensure the Extension cable is run so it can not be damaged or
tripped over.
Protect the Extension cable from damage from the environment,
animals, people or weather. Avoid mounting the Extension cable
in wet areas.
The Gallagher SmartReader BR Series Electronic Controller
needs to be able to be removed to recharge the internal batteries.
The extension cable length is 4 m.

3E0740 SmartReader Extension Mounting Kit Installation
Page 2
Procedure
1. Determine the location of the Electronic Controller based on the
above considerations.
2. Using the supplied metal tek screws attach the mounting bracket
to a solid mounting location using at least two of the holes in the
mounting bracket.
The two sets of two holes allows for installation on horizontal and
vertical pipe work.
3. Run the Extension cable from the Electronic Controller to the
Antenna Panel along the proposed path and temporally fasten the
cable in place.
4. Ensure the Electronic Controller is turned off.
5. On the Antenna Panel, unscrew the Amphenol connector locking
nut from the Amphenol socket and pull it down to unplug from the
Antenna Panel.
6. Connect the Extension cable to the Amphenol connector and
tighten.

3E0740 SmartReader Extension Mounting Kit Installation
Page 3
7. Mount the Electronic Controller on the mounting bracket by
grasping the Electronic Controller on both sides and slide the back
hand hold down onto the mounting bracket.
8. Connect the Extension cable to the Amphenol socket on the side
of the Electronic Controller and tighten the locking nut.
9. Once the Extension cable location is finalised, attach the cable
permanently using cable ties.
The SmartReader is now ready to use.
PUBLISHED BY
Gallagher Group Limited
Kahikatea Drive, Private Bag 3026
Hamilton, New Zealand
www.gallagherams.com
Copyright© Gallagher Group Limited 2006.
All rights reserved. Patents Pending.
Gallagher SmartReader BR Series Instruction Manual
3E0740 - October 2006