Gamber Johnson 7160-0392 User manual

HP/Canon Printer Mount
INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0392 Rev. A INST-553
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theoryof contract or tort law for any loss, damage, personal injury, special, incidental or consequential damagesfor personal injury orother damage
of anynature arising directly or indirectly asa result of the improper installation or use of its products in vehicleor any other application. In order to safely install anduse Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuellines, brakes lines, electrical, drive train or other systems), air-bags and othersafety equipment is
required. Gamber-Johnson specifically disclaims anyresponsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson productinstruction sheets, or workmanship standards as endorsedthrough the Gamber-Johnson Certified Installer Program.
©Copyright2011 Gamber-Johnson, LLC
Printing Spec. PS-001
1 / 2
The 7160-0392 HP/Canon Printer Mount is designed to hold HP 100 & H470 printers
and Canon i100 & i90 printers.
Older model HP and Canon printers, as well as other similar sized printers, may also
fit in the printer mount.
The 7160-0392 HP/Canon Printer Mount is typically used with a Gamber-Johnson
DS-74-L mount as described below.
The Printer Mount can also be installed in other arrangements, but the installer
may need to supply longer mounting hardware and spacers.
The Gamber-Johnson 7160-0351 isolator mount can be used with the printer mount
for extra protection against shock and vibration.
A 7/16" Socket & Rachet or Wrench and a Phillips Screwdriver are needed for installation.
1. The 7160-0392 Printer Mount
is shipped in it's most compact
form.
Loosen nuts securing the side and
back brackets to open the printer
mount.
Back Brackets
Side Brackets
Side Brackets

2 / 2
2. Typical install is a DS-74-L mount
attached to vehicle base or pole.
3. Attach printer mount to DS-74-L
with .25-20 screws, washers & nuts
supplied in hardware bag.
4. Insert printer into printer mount.
Center printer so paper feed doors
can be openned.
Move side and back brackets against
printer body and tighten in place.
Attach and secure power and
data transfer cables.
DS-74-L
Vehicle Base / Pole
.25-20 Flat Head Screws,
Washers and Nylok Nuts