Garmin tempe User manual

Instructions
WARNING
See the Important Safety and Product
Information guide in the GPS product box
for product warnings and other important
information.
Do not use a sharp object to remove
user-replaceable batteries.
Contact your local waste disposal department
to properly recycle the batteries. Perchlorate
Material —special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Separating the Sensor from the
Clip
1 Press the tab (1) on the clip.
2 Lift and separate the sensor (2) from the
clip.
Installing the Battery
1 Locate the circular battery cover (1) on
the back of the device.
2 Turn the cover counter-clockwise until it
is loose enough to remove.
3 Remove the cover.
4 Place the battery into the cover with the
positive side facing the inside of the
cover.
5 Replace the cover by aligning the dots
(2) and rotating clockwise.
Installing the Device
NOTICE
The sensor should be attached to a secure
strap or loop.
You can also place the sensor in an
exterior jacket pocket.
1Place the clip behind the strap or loop.
2 Align the arrow on the sensor and clip.
3 Snap the sensor into the clip.
Pairing the Sensor with your
Device
Before you can view temperature data on
your compatible GPS device, you must pair
the sensor with the device.
3
2

This procedure contains instructions for the
fenix. If you have another compatible device,
see your owner's manual.
1 Move 10 m away from other ANT-sensors.
2 Turn on the device.
3 Bring the device within range (9.8 ft. or 3 m)
of the sensor.
4 Select the Orange key.
5 Select Setup > ANT Sensor > Tempe >
New Search.
When the tempe is paired, the fenix displays
temperature data from the tempe instead of
using the internal temperature sensor. For
more information, see the fenix Owner's
Manual.
Tips
Place the sensor where it is exposed to
ambient air.
Avoid locations where sunlight, body heat, or
other conflicting hot/cold sources could affect
the sensor.
Specifications
Battery type
User-replaceable CR2032, 3
volts
Battery life
Up to 1 year
Water resistance
Water resistant to 32.9 ft.
(10 m)
Operating
From -4°F to 140°F
temperature range
(from -20°C to 60°C)
Radio frequency/
2.4 GHz ANT+ wireless
protocol
communications protocol
4
FCC Compliance
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and may
cause harmful interference to radio
communications if not installed and used in
accordance with the instructions. However, there
is no guarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and the receiver.
Connect the equipment into an outlet that is
on a different circuit from the GPS unit.
Consult the dealer or an experienced radio/
TV technician for help.
This product does not contain any user-
serviceable parts. Repairs should only be made by
an authorized service center. Unauthorized
repairs or modifications could result in permanent
damage to the equipment, and void your
warranty
5