Gasmate BQ1076 User manual

Important: Retain these instructions for future use.
Powerful 8MJ/h stainless steel burner for true
BBQ performance
Piezo ignition for easy lighting
Generous cooking area of 45 x 29cm
Reversible satin enamel cast iron cooking surface
Complete unit packs down into sturdy storage
and carry case
Includes stainless steel braided hose to suit
3/8” BSP LH cylinders
Gas certified to Australian Standards
Model No. BQ1076
03617 09/17
Gasmate® is a registered trademark of
Sitro Group Australia Pty Ltd www.gasmate.com.au
Aber, N.Z. www.gasmate.co.nz
For any queries or assistance call
Customer Service (Australia Only)
1300 174 876
Hours of operation: Monday to Friday 8am - 5pm EST
Do not return to place of purchase.
Keep your purchase receipt, this will be required to
make any claims under the 12 month warranty.

2
3
READ ME FIRST
GAS LEAK TESTING
It is important that you leak test the BBQ before first use and every time the gas
cylinder is refilled and reconnected to the BBQ.
To Complete Leak Test
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spray bottle apply the soap solution to the gas line and each
join in the gas line including:
- the gas connection at the inlet of the BBQ
- all gas hose connections
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the
connection DO NOT PROCEED.
• Replace gas hose
• Replacement hose can be purchased from your local BBQ retail specialist.

2
3
GENERAL INFORMATION
Barbecues for use with bottled gas are labelled
‘propane gas’.
Clearances
Minimum Clearances from combustible materials
must be:
Rear - 300mm
Sides - 300mm
Above - 1000mm
Specifications
Barbecue specifications can be found on the
data label attached to the barbecue body.
Hose connection thread is 1/4” B.S.P.
IMPORTANT
Read these instructions carefully prior to
use. Familiarise yourself with the appliance
before connecting it to it’s gas container.
Keep these instructions for future reference.
IF YOU SMELL GAS
1. Shut off gas to the barbecue at its
source, if possible.
2. Extinguish any open flame.
3. If odour continues immediately call your
gas supplier or fire department.
Hose Safety
When connecting the hose assembly to the gas
cylinder, take care to avoid unnecessary twisting
of the flexible hose.
After the assembly has been secured, turn on
the gas and check for leaks by brushing a soap
and water solution over all connections.
If you are unable to correct the leak by tightening
the connections, turn off the gas and contact the
supplier immediately.
Always ensure the barbecue is kept away from
flammable materials and the gas cylinder clear of
any heat source.
When changing over from an empty gas cylinder
to a full one make sure this procedure is carried
out in a well ventilated location, preferably
outside, away from people and away from any
sources of ignition; such as naked flames, pilot
flames, electric heaters/equipment.
Gas Cylinder Use & Safety
This is a high pressure barbecue and must only
be used as supplied. Your barbecue is designed
for use with camping gas cylinders certified to
AS 2469.
The gas cylinder should be filled by a reputable
gas supplier and visually inspected and re-
qualified at each filling.
Always keep cylinder in an upright position.
Always close the cylinder valve when the
barbecue is not in use.
Do not subject gas cylinder to excessive heat.
NEVER STORE YOUR GAS CYLINDER INDOORS.
If you store your barbecue indoors, ALWAYS
disconnect the gas cylinder first and store the
cylinder safely outside.
Cylinders must be stored outdoors in a well
ventilated area out of reach of children, and must
not be stored in a building, garage or any other
enclosed area.

4
5
FOR YOUR SAFETY
Failure to comply with these instructions
could result in a fire or explosion which
could cause serious bodily injury, death or
property damage.
CAUTION: Accessible parts may be very
hot.
Keep young children away.
DO NOT modify this appliance.
DO NOT move this barbecue during use.
Turn off gas supply at the gas cylinder after
use.
Parts sealed by the manufacturer or their
agent must not be manipulated by the user.
This barbecue is only to be used and stored
outdoors.
• Do not test for gas leaks with an open
flame.
• If this information is not followed exactly
a fire causing death or serious injury
may occur. Do not store a spare gas
cylinder under or near this barbecue. This
barbecue is only to be used and stored
outdoors.
• If there is a leak on your appliance (smell
of gas) immediately attempt to turn off
the cylinder valve. Remove the appliance
to a well ventilated location away from
any ignition source. Only check for leaks
outdoors using soapy water. DO NOT try
to detect leaks using a flame.
• Check for leaks by brushing a soap and
water solution over all connections. If
you are unable to correct the leak by
tightening the connections, turn off
the gas and contact customer service
immediately.
GENERAL INFORMATION
• Only use the hose assembly as supplied
with this appliance for connection to the
cylinder - DO NOT USE ADAPTERS.
• Maximum hose length - 1000mm.
• After use turn the gas cylinder valve off
and wait for the flame to go out.
• Avoid twisting or kinking the flexible
hose.
• Do not store or use petrol or other
flammable liquids in the vicinity of this or
any other appliance.
• Do not store empty or full spare gas
cylinders under or near this or any other
appliance.
• Never test for gas leaks with a lit match
or open flame.
• Never lean over cooking surface when
lighting.
• Never alter or modify the gas supply
assembly.
• This barbecue must not be used indoors.
• Only use in well ventilated areas.
• CARBON MONOXIDE HAZARD - USING
THIS APPLIANCE IN AN ENCLOSED
SPACE MAY CAUSE DEATH. DO NOT
USE IN CARAVANS, TENTS, MARINE
CRAFT, CARS, MOBILE HOMES OR
SIMILAR LOCATIONS.
• Ensure the barbecue is set up on a level
and stable surface.
• Do not move the barbecue while in use
or when hot.
• Do not use this appliance if it is leaking,
damaged or does not operate properly.

4
5
IF THERE IS A LEAK
• Turn the cylinder off.
• Ventilate the area to disperse gas.
• Check all connections.
• If leak persists, keep the cylinder upright.
Keep skin away from any gas or liquid
escaping from the cylinder.
• Keep the cylinder at least 20 metres
away from any sparks or ignition sources,
including electrical equipment, camera
flashes, engines and motors.
• Disperse gas by encouraging maximum
ventilation and spraying with a fine water
spray.
IF THERE IS A FIRE
• If the fire is at the barbecue, turn the gas
off at the cylinder. Smother the flames
with a wet cloth, fire blanket or extinguish
using a fire extinguisher.
• If the fire is at the cylinder, or you can
not get to the valve to turn the gas off,
contact the fire brigade immediately.
• Using a garden hose, direct the water to
the middle of the cylinder to keep it cool.
Try not to extinguish the flame. At least
if the gas is burning, it won’t be able to
build up pressure and explode.
Location of your Barbecue
DO NOT use your barbecue in garages, porches,
sheds, breezeways, or other enclosed areas.
Your barbecue is to be used OUTDOORS. The
barbecue is not intended to be installed in or on
recreational vehicles and/or boats and should
not be placed under any surface that will burn.
Do not obstruct the flow of combustion and
ventilation air around the barbecue housing.
Protect Children
Keep children away from barbecue during
use and until barbecue has cooled after you
have finished. Do not allow children to operate
barbecue.
Always ensure that no sporting or physical
activities are carried out in close proximity to the
barbecue during use and while still hot.
Check Barbecue for any Damage
Inspect barbecue parts as you proceed.
Contact your supplier for assistance regarding
replacement of any damaged or missing parts.
Do not assemble or operate a barbecue that
appears damaged. Barbecues for use with gas
cylinders are labelled ‘Propane Gas’.
This appliance is designed to use a camping gas
cylinder.
IT MAY BE HAZARDOUS TO ATTEMPT TO
FIT OTHER TYPES OF GAS CONTAINERS.
Check labelling at the gas connection on your
barbecue.
Nominal Hourly Gas Consumption
Main Burner
Gas Type Propane
Inj. Size 0.138 mm
Gas Cons. 8 MJ/h
Gas Pressure Cylinder

6
7
GENERAL INFORMATION
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual.
Check
1. Gas cylinder is filled. A sloshing sound will be
heard when shaken.
Connecting
1. Ensure valve is in OFF position.
2. Check for any damage to the cylinder
connection.
3. Attach the hose to the cylinder valve and
tighten firmly with a spanner.
4. Use a soapy water solution to check the joint. If
bubbles appear the connection will need to be
re-tightened.
LIGHTING PROCEDURE
Burner Operation & Ignition System Check
1. With cylinder valve in ‘OFF’ position check the
piezo igniter by pushing in. Check for sparking to
the burner.
2. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to
the control and sparker tip.
3. With sparking established install the hotplate
and open the cylinder valve whilst pushing the
igniter.
4. If the burner fails to light after several attempts turn
off gas and inspect for obstructions to gas flow.
If re–ignition is necessary while the gas barbecue is
still hot, you must wait for a minimum of 5 minutes
before commencing to re–ignite (this allows
accumulated gas fumes to clear).
Overall Barbecue Dimensions
Length Width Height
500mm 300mm 290mm
IMPORTANT
• CAUTION: When the barbecue is
not in use, the gas cylinder must be
disconnected.
• Check that the seals between the
appliance and the gas cylinder are in place
and in good condition before connecting
the gas cylinder.
• Do not use this appliance if it has
damaged or worn seals.
• NOTE: If for some reason, ignitor fails
to produce a spark at the electrode,
barbecue can be lit by a long barbecue
match.
• Do not smoke when attempting to ignite
barbecue.
• Always use protective gloves when
handling hot components.

6
7
OPERATION
IMPORTANT
Do not smoke at any time when attempting
to ignite the barbecue burners.
Do not leave the barbecue unattended
when alight.
BURNER OPERATION & IGNITION SYSTEM CHECK
Problem Possible Reason Solution
Burner will not ignite
No gas Replace gas cylinder
Piezo igniter is faulty Use a long barbecue match
Food is not cooking
or is taking too long
Burner has gone out Check that the gas bottle is not empty
and re-ignite the burner
Cooking surface was not given
enough time to warm up before
the food was applied
Remove the food and give the burner time
to warm the cooking surface (5-10 mins)
There is too much food on the
cooking surface Cook smaller portions
ASSEMBLY
Slide the four legs into the holders on the
underside of the body.
Insert the bayonet tube into the centre hole
rotating it clockwise and ensure it is securely
attached.
Attach the hose to the 3/8” BSP LH fitting of the
gas cylinder and tighten firmly with a spanner.
SERVICING
Servicing should be conducted every year or
sooner if required.
The appliance must only be serviced by an
authorised person.

8
This appliance shall only be used in an above ground open-air situation with natural ventilation,
without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by
wind and natural convection.
Any enclosure in which the appliance is used shall comply with the following:
An enclosure with walls on all sides, but at least one permanent opening at ground level and no
overhead cover.
Within a partial enclosure that includes an overhead cover and no more than two walls.
Within a partial enclosure that includes an overhead cover and more than two walls,
the following will apply:
at least 25% of the total wall area is completely open, and
at least 30% of the remaining wall area is open and unrestricted.
In the case of balconies, at least 20% of the total wall area shall be and remain open
and unrestricted.
SAFE APPLIANCE LOCATIONS
DIAGRAMMATIC REPRESENTATIONS OF OUTDOOR AREAS
The following figures are diagrammatic representations of outdoor areas. Rectangular areas have been
used in these figures – the same principles apply to any other shaped area.