Gayla 640 User manual

3-D KITE STOCK NO. 640,644
ASSEMBLY INSTRUCTIONS
BEFORE BEGINNING, CAREFULLY READ
THE INSTRUCTIONS. NEXT, SEPARATE
ALL PARTS INTO GROUPS ACCORDING
TO THE ILLUSTRATION ON YOUR RIGHT.
SEE ILLUSTRATIONS BELOW TO BEGIN.
STEP 1:
INSERT WING BRACES
INSERT BRACES A UNDERNEATH THE PLANE.
LOCATE THE MIDDLE STRUT CONNECTORS UNDER
THE PLANE WING TOWARDS THE NOSE. INSERT
THE BRACE RUNNING VERTICALLY FROM THE MIDDLE
TOP CONNECTOR TO THE BOTTOM CONNECTOR.
REPEAT FOR BOTH SIDE. SEE ILLUSTRATION.
BOTTOM VIEW
BRACE A APRROX. 11.5" 2 OF 2 (WING BRACE)
BRACE C APRROX. 35" 2 OF 2 (BODY BRACE)
BRACE B APRROX. 3.25"
2 OF 2 (WING STRUT) WHEEL 2 OF 2
PARTS LIST
STEP 2:
INSERT WING BRACES
ATTACH WHEELS TO BRACES B.
SEE ILLUSTRATION.
BOTTOM VIEW
A A
MIDDLE
BRACE
CONNECTORS
STEP 3: ASSEMBLE WHEEL BASE
INSERT STRUT STRUT 1 INTO CONNECTOR.
THEN INSERT 2 AND 3 .
3
2
1
B
3
2
1

GP 4744 AUG 29, 02 2 OF 2
M.R.
®
INDUSTRIES, INC.
PO BOX 920800 HOUSTON TEXAS 77292-0880
WEB ADDRESS: www.gaylainc.com
STEP 6:
ATTACH TWINE TO KEEL
LOCATE KEEL UNDERNEATH PLANE.
THE KEEL RUNS FROM THE FRONT OF
THE WING TO THE BACK OF THE
WING UNDERNEATH THE PLANE.
LOCATE THE LOOP IN THE MIDDLE OF
THE KEEL AND TIE TWINE THROUGH THE LOOP.
NOW YOUR 3-D KITE IS READY TO FLY!
STEP 5: ATTACH SPINNING
GYRO TAIL
LOCATE HOLE UNDERNEATH PLANE
TOWARDS THE TAIL END. OPEN
PIN ON END OF STRING ATTACHED
TO THE TAIL. INSERT THROUGH HOLE.
CLOSE TAIL PIN.
BOTTOM VIEW
C C
TOP VIEW
INSERT BODY BRACES C INTO MAIN BODY THROUGH
THE LOOPS SEWN IN THE MIDDLE INSIDE THE KITE.
CROSS BRACES AT EACH END AND PLACE BRACE
ENDS INTO POCKETS AT EACH END OF KITE. SEE
ILLUSTRATION FOR PLACEMENT.
STEP 4: ASSEMBLE BODY BRACES
KEEL