10
ADAPTER INSTALLATION
• To avoid scratching the screen, place a cloth on
a at surface on which the television will be sup-
ported.
NOTE: The installation method of the adapter
depends on the type of electrical connection; for
the type in Figure A: install following point 3-1; for
the type in Figure B: following point 3-2
• Place the television with the screen facing
downward. Place the adaptor and the spacer on
the back of the television, and align the holes.
• Mount the adapter and the spacer on the back
of the screen by using the relative combination
of screws and washers as illustrated in Figures
3.1 and 3.2.
• Start with the shortest screw, insert it in the
washer, and install the adapter or the spacer on
the television as illustrated here below.
• The screw must make at least three complete
turns in the mounting hole and situate itself
comfortably in its seat. Do not overdo the
screwing.
• If the screw does not make three complete
turns, choose a longer screw from the screw
package. Repeat the same operations for the remaining holes, level the pins and tighten the
screws.
• Start with the longest screw, insert it in the washer,
and install the adapter or the spacer on the television
as illustrated here below.
• The screw must make at least three complete turns
in the mounting hole and situate itself comfortably in
its seat. Do not overdo the screwing.
• If the screw does not make three complete turns,
choose a longer screw from the screw package. Re-
peat the same operations for the remaining assembly
holes and tighten the screws.
fig. 3.2
b
32mm
M-B
M-D
M-F
M-H
M-I
M-J
M-K
M-L
M-A
M-C
M-E
M-G
C
BM-I
M-J
M-K
M-L
