GE Interlogix DS-150 User manual

DS-150/850/450/950/1200/1500 4-inch Mini-Dome Cameras
1036339B / January 2003 Technical Support: 800-469-1676 1
CEILING MOUNTING
1) Position the unit on the mounting surface so that the lens points toward the area you want to view.
2) Mark the position of the mounting holes and cable hole (see Figure 1).
3) Screw the provided #6x1-inch screws halfway into the mounting surface.
4) Cut a hole in the mounting surface to accommodate the camera cables.
5) Attach the camera’s video out BNC connector (see Figure 2) to the receiving device’s video in BNC connector.
6) Attach the camera’s power cable (see Figure 2) to your power source.
7) Feed the cables through the hole.
8) Place the mounting holes over the screws and turn the unit clockwise.
9) Tighten the mounting screws until snug.
Figure 1. Mounting holes
Mounting holes (2)
Cable hole
Camera base
Camera base
Camera
Power cable
Video out BNC
Figure 2. Parts of the camera

DS-150/850/450/950/1200/1500 4-Inch Mini-Dome Cameras Installation Instructions
2 © 2003 Kalatel, a GE Interlogix company 1036339B / January 2003
BRACKET MOUNTING
1) Place the wall-mount bracket against the mounting surface.
2) Mark the position of the mounting holes (see Figure 3).
Note: The bracket will lower approximately 0.5 inch (1.25 cm) when resting on the mounting screws.
Wall-mount bracket
Mounting holes (2)
Figure 3. Mounting holes of the wall-mount bracket
3) Screw the provided #6x1-inch screws halfway into the mounting surface.
4) With a screwdriver, remove the top of the wall-mount
bracket (see Figure 4).
5) On the underside of the wall-mount bracket, screw the two
provided 3.5x10 mm (brass) screws halfway into the holes
that correspond with your camera (see Figure 4).
6) Attach the camera’s video out and power cables as shown in
Figure 2. See steps 5 and 6 in Ceiling Mounting.
7) From the underside of the wall-mount bracket, feed the
camera cables through the cable hole (see Figure 4).
8) Place the mounting holes of the camera base over the
screws in the wall-mount bracket.
9) Turn the camera base clockwise.
10) Tighten the screws until snug.
11) Run the camera cables through one of the rectangular
openings in the back of the wall-mount bracket.
12) Replace the top of the wall-mount bracket, and secure it
with the provided 3x8 mm (brass) screws.
Top
Underside of top
Cable hole
Camera screw holes (4)
Wall-mount bracket
13) Place the wall-mount bracket mounting holes over the
screws in the mounting surface.
Figure 4. Top of wall-mount bracket
14) Lower the wall-mount bracket so that it rests on the mounting screws.