PSI23SGM—GE Profile Arctica™22.6 Cu. Ft. CustomStyle™Side-by-Side Refrigerator with Dispenser
Specification Revised 3/01
An enclosure is required to match
up to the trim, see Typical
Installation. To obtain the most
integrated look, the cabinet or soffit
above the refrigerator should extend
out to the same depth as the side
panels. The refrigerator opening
must have minimum dimensions
of 70-1/4" high x 36-1/8" wide x
24-1/2" deep as shown at right. If
there is an overhead cabinet, allow
1" for cabinet door clearance with
the top trim piece so the cabinet
doors can be opened without hitting
the top trim. If 1/2" side panels are
used, then side trim and panel will
be even. If 3/4" side panels are used,
then some of the side panel will
extend beyond the trim and must
be finished.
Collar Trim Installation
25"
Counter
Top
ElectricalWater
Trim
3/4" Airspace
(1/2" Gap + 1/4"
Wall Plates)
24"
Cabinet
Typical Installation
Shaded areas represent front surfaces of
side panels and overhead cabinet or soffit that contacts trim.
Overhead
Cabinet
Cabinet
Door
Top Trim
Case
1"
Magnetic
Tape
3/4" Cabinet
Side Panel
1/2" Cabinet
Side Panel
Side trim must be installed
flush with the gasket contact
surface on the case.
Refrigerator
Case
Side TrimDoor Gasket
IMPORTANT: Before finalizing specifications for your GE Profile™
CustomStyle™Refrigerator, please NOTE:
•A minimum of 36-1/8" is required for refrigerator installation with collar
•Be sure to allow for 1/2" or 3/4" side panels in addition to the 36-1/8" minimum
70-1/4"*
36-1/8"
24-1/2"*
1/2" minimum
*The rough-in dimension of 70-1/4" is minimum and is measured from the
finished floor to top of opening (or the underside of the overhead cabinets).
For Models with Trim Kit: If frameless style cabinets are planned for above the
refrigerator, you may need to consider adding a maximum of 1/4" (70-1/2") to
height of opening to allow additional clearance between cabinet doors and
top of refrigerator trim when cabinet doors are in open position.
Manufacturer Certified to
ASSOCIATION OF HOME
APPLIANCE MANUFACTURERS
ANSI/AHAN HRF-1-1979
VOLUME and
SHELF AREA
Total volume and shelf
area are calculated by the
Association of Home
Appliance Manufacturers’
standards.
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®GE Profile™or
GE appliance questions, visit our website at
WWW.GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
