Genesis HD-DNBC User manual

HIGH DEFINITION SERIAL DIGITAL INTERFACE
OSD CONTROL - USER’S GUIDE

CONTENTS
● FEATURES
● PRECAUTIONS
● PART AND FUNCTION
FRONT
LENS
CONNECTING THE CAMERA TO THE MONITOR
BACK
● CONNECTIONS
● CAMERA OPERATIONS
● TROUBLE SHOOTINGS
● SPECIFICATIONS
- 01 -

FEATURES
● HORIZONTAL RESOLUTION 1000 TV LINS
● DAY & NIGHT FUNCTION
● 3DDNR (3D DIGITAL NOISE REDUCTION)
● WDR (WIDE DYNAMIC RANGE)
● PRIVACY FUNCTION
● ADDITIONAL FUNCTION
● CONTROLLED OSD MENU
Sencor :1/3”Progressive Scan CMOS / Min.Illumination : 1 Lux at 1.2 / 0.1 Lux (B/W)
WHITE BAL, MOTION DETECTION, MIRROR, SHARPNESS, FREEZE, DZOOM,
SHADING, HLM, ACE Function are also available.
twenty-eight
- 02 -

PRECAUTIONS
- 03 -

PART & FUNCTION
BACK
CVBS : It is a video analog BNC connector.
HD-SDI : It is HD-SDI video signal output BNC connector.
- 05 -

LENS
CONNECTION
- 06 -

CONNECTION
- 07 -

CONNECTING POWER
CONNECTION
- 08 -

CONNECTING THE CAMERA TO THE MONITOR
CONNECTION
▶ Connect to use a converter when connect
HD-SDI output with general monitor.
▶ Video cable.
The cable to connect a video output of the camera and the monitor is BNC coaxial cable same
as the below. If the install distance between a camera and the monitor is over the max video
transmission range, please use the separated video amplifier.
Max video transmission range Recommended cable specification
100 ~140m 5C2V (75ohm)
200m L-6CHD (75ohm)
(SDI exclusive cable)
- 09 -

CONNECTION
Using a RS-485 communication, it will be able to control the OSD menu
at the System Controller or DVR.
CONNECTING TO RS-485 CONTROL CABLE
• When you construct external control systems for a camera control, please
use to the PROTOCOL or PELCO-D PROTOCOL.
• When you connecting to RS-485 control cable, please peel off the outer
skin inside the RS-485 control cable.
485 Control Board Connection Port
(+) CONNECTION TERMINAL (R+)
(-) CONNECTION TERMINAL (R-)
RS-485 Control Port
485+
485-
RS-485 Communication establishment initial value
Item
Initial value
Camera ID
0
BAUD RATE
9600
UART MODE
8-NONE-1
RET PKT
Not supported
NOTES
(1) The case which it controls from the PC
Using a RS-485 converter, It connects to RS-485 control cable outside camera
and serial cable
EX) SERIAL PORT OF THE PC(COM1) → SERIAL CABLE → RS-485 CONVERTER
→ RS-485 CONTROL CABLE
(2) The case which it controls from the DVR or System Controller
It connects the RS-485 control cable in the connection terminal of 485 control
boards which are connected with the DVR or System Controller.
- 10 -
System Controller