GENEVO One S User manual

USER MANUAL
Radar Detector Genevo One S

Congratulations on your purchase of world´s most intelligent radar
and laser detector Genevo One S.
Main functions of Genevo One S
Genevo One S is the most powerful detector from Genevo family and is designed to protect the driver from speeding fines.
Genevo One S communicates with driver in English language and its main functions are detection of microwave radars (X / K
/ Ka bands), laser guns, red light cameras and sectional speed cameras (using its own GPS database).
Notifications:
Text warning and voice alert appears on Genevo One S during radar alert. Strength of the signal and beeps expresses the
intensity of the received signal. Signal strength has ten levels. GPS alerts are reported by voice. For example “Speed
Camera”.
Control:
1) Left button MENU / ON-OFF
Short press: You will enter into setup menu.
During the signaling radar you will mute the volume. The next alarm will be reported again in the standard volume.
Long press: Turn ON / OFF Genevo One S.
Radar Detector Genevo One S

2) Middle button BRIGHTNESS / ALERT SUPPRESSION
Short press: You can change the brightness of the display - Bright -> Dim -> Smart Dark -> Full Dark.
Long Press: If you hold it during an alert you will mark the place of false radar reporting so at a given point detector during the
next passage will be suppressed. If you suppress a false alert, detector will not detect radars in radius of about 150 meters.
Hold button during the "suppressed" radar alert and this listing will be canceled. After next passage radar alert will be
signaled acoustically.
3) Right button SENSITIVITY / ADD YOUR OWN GPS POINT
Short press: You can scroll between Highway / City / Auto City modes. In City or Auto City modes the sensitivity of X / K / Ka
bands can be reduced according to user preference.
Long Press: Add your own GPS point.
4) Buttons on the right side + / -
Short press: Changing volume of the detector.
Menu:
Press for enter into menu.left button
Press to go from one category to the next.left button
Press VOLUME or (on the right side of detector) to change your setting .+ – within a category
To complete this change, simply wait a few seconds without pressing a button. The unit will display “Seting Completed” to
confirm your selection. Alternatively, you can get out of the menu by pressing the .right button
Radar Detector Genevo One S

Items in the menu are as follows:
(recommended settings are highlighted)
Sensitivity: Highway / City / Auto City
Setting the speed in Auto City (item is present only if the sensitivity is set to Auto City): Through you are selecting Middle button
between speeds for editing (left number indicates the speed below which the detector will not respond to alerts. Right number
indicates the speed below which the detector will detect alerts like in City mode). + / - buttons on the right side of the detector change
the specific speed. When detector is set up to “20 50” speed below 20 km/h on the radar will not respond. In the velocity range 20-50
km/h will only respond to stronger radar signals. Maximum detector sensitivity on the radar starts from 50 km/h.
Setting values City and Auto City sensitivity (entry is present only if the detector sensitivity is set to other than Highway): Via Middle
button + / - you can select radar band for editing. To change the signal level which will respond to radar signals use . The level of
suppression can be selected in the range 0-9. For example, when setting is X2 K2 and Ka2 the level of detection in all bands are slightly
decreased.
Display Mode: Speed/Time, Speed/Voltage, Battery Voltage, Time, Speed, Speed/Compass
Auto Mute: On / Off: If it´s activated, after two seconds of ongoing alert the volume will be reduced.
The minimum speed for signaling radar: Off, 10 km/h, 20 km/h, 30km/h ......... .. 130 km/h
X-Band: On / Off
K-Band: Wide / Narrow / Instant Only / Off (In countries, where police use K band radars, it is recommend to use K Narrow setting)
Radar Detector Genevo One S

Ka-Band: Wide / Narrow / Off
Ka Filter: Off / Normal / High - Filtering false alerts from blind spots and ACC. (When Ka Filter is activated, detection distance on Ka
band radars is slightly reduced. We recommend using „Normal“ which is very good in sensitivity/false alerts immunity ratio.)
Laser: On / Off
Startup sound: On / Off
GPS connect announce: On / Off
GPS detection by database type: Via you can select the type of GPS points. For editing use + / -. You can turn on and Middle button
off particular type of point.
GPS warning distance: Normal (approx. 250m) / Farther (approx. 375m) / Farest (approx. 500m)
Setting local time: You can change time zone via + / -
Language: English / Deutsch / Czech
Factory reset: For reset press . middle button
Delete all user points: For deleting all user points press .middle button
Radar Detector Genevo One S

SpeedMeter Option:
This function is intended for legalization of the detector when used in countries where radar detectors are illegal. The
detector stops alerting you on GPS points, radars and lasers and there is only current speed shown at the display. To activate
this function you need to hold and button for approximately 5 seconds. After that you will enter into middle right
SpeedMeter. In SpeedMeter mode GPS points, radars and laser functions are disabled. To reactivate SpeedMeter function
you need to hold and + and then plug it into power source. You need to hold it approximately 8 seconds. right button button
After 8 seconds display will show SpeedMeter OFF. Now you have fully working detector again.
Radar Detector Genevo One S

Database Updates:
Database update is recommended to check once in three months.
Download the new database is performed according to the instructions www.genevo.com/en/updates/
while at www.genevo.com/en/updates-subscription
you can register and receive notifications of new and updated database to your email.
Radar Detector Genevo One S
Operating frequency:
GPS: SiRF STAR IV
Ka narrow: 34,0GHz, 34,3GHz, 34.7GHz, 35,5GHz
(±120MHz)
Ka wide: 33.4 GHz ~ 36.0 GHz
K narrow: 24.125GHz (±70MHz)
K wide: 24.125GHz (±150MHz)
X band: 10.525GHz (±50MHz)
Laser: 904nm
Technical parameters:
Operating temperature: -20 +85 °C
Storage temperature: -20 +85 °C
Operating voltage: 11 – 16 V
Energy consumption: 250mA normal, 330mA
max. (12V)
Dimensions: 62 * 92 * 34 mm

Your Dealer:
Manual REV: 2016-08-18
Radar Detector Genevo One S