Genmega G1900 EMV User manual

How To Install:
G1900 EMV Upgrade Kit

Tools Needed:
Phillips Screw Driver
- Begin by verifying the contents of the kit
Kit includes:
-MCR outer bezel
-MCR mounting brackets
-EMV MCR (card reader)
-Reset board
-Reset board to mainboard wire
-2 reset board screws.

Unlock and slide open the ATM top housing.
Power the ATM off using the power supply switch.
There are 2 screws (right and left side) that hold the front
bezel up. Remove both screws, which will allow the front
bezel to hinge forward and provide access to the card
reader.

Now you can remove the existing card reader assembly:
-Unplug the LED wire and the MCR wire(red squares)
-Unscrew 7 screws(red circles),
-MCR outer bezel will come off from the front.

Remove the bracket which comes installed on the new card
reader. Save the 2 screws. This bracket will be discarded.

Install G1900 mounting brackets onto the EMV MCR. Make
sure to use the holes further from the front as shown in the
picture below.
The cut-outs in the mounting brackets allow them to only be
installed one way. Use the photo for reference.

Attach the EMV MCR into the new MCR outer bezel using the
screws from the previous Swipe-style card reader.
The card reader should fit easily into the back of the bezel.

Now you need to install the reset board onto the side of the
mainboard.
Make sure the switch on the reset board is to the right
(see red circle).
Plug your reset board wire to the mainboard (see red
squares). Now insert you reset board into the mainboard.

Attach the reset board into the mainboard with the 2 screws
provided.

Attach the new outer bezel (6 red circles) using the screws
off the old bezel.
Connect the card reader LED wire (red square).
Then attach the EMV black ground wire with the green wire
on the slide tray(green circle).