Geotab GO9+ User manual

Rev 0.5 - 06/2020 - PAC-INSUNI205
Telematics Device Quick Start
Read before installing: gtb.page.link/yXpm
27mm
77mm 53mm
1876
Note: To connect to your WiFi hotspot, the device
MUST nish provisioning (all LEDs should
turn solid) and your vehicle ignition must
be on
Please ensure your device is connected and
communicating, then follow the steps below to
enable and connect to the Wi-Fi hotspot:
1) In MyGeotab, navigate to Vehicles in the main
menu.
2) On the Vehicles page, select the desired vehicle
from the list.
3) On the Vehicle Edit page, select the Wi-Fi tab.
4) Under the Wi-Fi tab, toggle the Enable hotspot
toggle to On.
5) In the SSID eld, enter a unique SSID. The
information entered in this eld indicates the
Wi-Fi network name.
6) In the Password eld, enter a unique password
for the Wi-Fi network.
7) Click the Save button to save your changes.
8) On the desired mobile device, navigate to device
settings then select the desired Wi-Fi network
and enter the password.
Note: The Wi-Fi network name and password
are the same as the information entered in
Steps 5 and 6.
How to Set Up the GO9+
Wi-Fi Hotspot
Report
Sort by: Name MoreAddShowName, VIN, or serial num
Vehicles 1 Vehicle
Test Vehicle
Company group
G9XXXXXXXXXX 332692 km
ABCDEF1234567890
Columns
Vehicle Edit Test Vehicle ?
Device
Enable hotspot
SSID:
Passwords:
Confirm password:
HOTSPOT SETTINGS
Driver feedback Groups Service plan Wi-Fi
OffOn
Save Remove Cancel View on map More details Personal Mode
In the box:
G9-SAM-PLE-1234
GO9-AAAAAA
G9-SAM-PLE-1234
GO9-AAAAAA
G9-SAM-PLE-1234
GO9-AAAAAA
G9-SAM-PLE-1234
GO9-AAAAAA

4
2
Installation:
1
www.installmygps.com
1
Name:
Company:
Serial No:
John Smith
ABC Company
G9-SAM-PLE-1234
Log Install
2
5432
Verify Install:
Device Communicating
G9-SAM-PLE-1234
3A
Device Not Communicating
G9-SAM-PLE-1234
3B
3