Getnet GR-534W User manual

1

2
CATALOG
1Overview............................................................................................................1
2Hardware Description and Hardware Installation...............................................2
2.1 Front Panel and LED Status..................................................................2
2.2 Rear Panel and Interface Description ...................................................3
2.3 Hardware Installation.............................................................................4
2.3.1 System Requirements ................................................................4
2.3.2 Before You Begin........................................................................4
2.3.3 Connecting AP............................................................................4
2.4 Operation Range...................................................................................5
2.5 Roaming................................................................................................5
3Network Configuration and Introduction to Network Connection Modes ...........7
3.1 TCP/IP Settings.....................................................................................7
3.2 Introduction to PPPoE (ADSL) and DHCP (Auto config).....................10
3.3 Connection Introduction for Ethernet User..........................................13
3.4 Connection Introduction for Wireless User..........................................13
3.5 Log In to the Web Page.......................................................................16
4Quick Start........................................................................................................18
4.1 Quick Start in the Bridge Mode............................................................18
4.2 Quick Start in the Gateway Mode........................................................20
4.2.1 System Management................................................................21
4.2.2 LAN Settings.............................................................................21
4.2.3 WAN Settings ...........................................................................23
4.2.4 Wireless Settings......................................................................23
4.2.5 Wireless Security......................................................................25
4.3 Quick Start in the WISP Mode.............................................................25
5Web Configuration ...........................................................................................28
5.1 Overview..............................................................................................28
5.1.1 Status........................................................................................28
5.1.2 Statistic .....................................................................................29
5.1.3 Management.............................................................................29
5.2 Operation Mode...................................................................................30
5.3 Internet Settings ..................................................................................31
5.3.1 LAN...........................................................................................32
5.3.2 WAN .........................................................................................34
5.3.3 Advanced Routing ....................................................................39

3
5.3.4 DHCP Client .............................................................................42
5.3.5 QoS...........................................................................................43
5.4 Wireless Settings (Gateway Mode).....................................................50
5.4.1 Basic.........................................................................................51
5.4.2 Advanced Settings....................................................................58
5.4.3 Security.....................................................................................66
5.4.4 WPS..........................................................................................75
5.4.5 Station List................................................................................80
5.4.6 Wireless WDS Setting ..............................................................80
5.5 Wireless Settings (WISP Mode)..........................................................90
5.5.1 Profile........................................................................................91
5.5.2 Link Status................................................................................97
5.5.3 Site Survey ...............................................................................97
5.5.4 Statistics..................................................................................100
5.5.5 Advance..................................................................................101
5.5.6 QoS.........................................................................................104
5.5.7 11n Configurations..................................................................106
5.5.8 WPS........................................................................................108
5.5.9 About ......................................................................................120
5.6 Firewall..............................................................................................121
5.6.1 Filtering...................................................................................121
5.6.2 Virtual Server..........................................................................124
5.6.3 DMZ........................................................................................127
5.6.4 System Security......................................................................127
5.6.5 Content Filtering .....................................................................129
5.7 Administration....................................................................................131
5.7.1 Management...........................................................................131
5.7.2 Upload Firmware ....................................................................134
5.7.3 Settings Management.............................................................135
5.7.4 Status......................................................................................135
5.7.5 Statistic ...................................................................................136
5.7.6 System Log.............................................................................137
6Troubleshooting .............................................................................................139

4
About User Manual
This user manual mainly describes how to install and configure the Getnet GR-534W
wireless router.
Organization
The GR-534W User Manual is organized as follows:
Chapter Description
Chapter 1 : Overview Provides a general overview of the
GETNET GR-534W wireless router, and
the package list.
Chapter 2 : Hardware
Description and Hardware
Installation
Mainly describes the front panel and the
rear panel of the GETNET GR-534W and
the procedure for hardware installation.
Chapter 3 : Network
Configuration and
Introduction to Network
Connection Modes
Describes how to configure the network
settings and provides the introduction to
network connection modes.
Chapter 4 Quick Start Provides quick start for configuring
GETNET GR-534W.
Chapter 5 Web
Configuration Mainly describes how to navigate through the Web pages and how to configure the
parameters.
Chapter 6 : Troubleshooting Describes how to solve some simple
problems.
Features
Support IEEE802.11b, IEEE802.11g, IEEE802.11n, IEEE802.3,
IEEE802.3u, IEEE802.11i, and IEEE802.11e
The transmission data rate is up to 150 Mbps
Support WEP and WPA for data transmission security
Support DHCP Server and Client
Support static and dynamic routing

5
Support upgrading firmware version via Web page
Support restoring factory default settings
Support virtual server
Support DMZ (demilitarized zone)
Support DNS proxy and forwarding
Support setting QoS bandwidth, and generating rules based on protocol,
port, IP, DSCP, or application
Support wireless security authentication modes, including Open, Shared,
WEPAUTO, WPA-Enterprise, WPA-PSK, WPA2-Enterprise, WPA2-PSK,
WPA-PSK/WPA2-PSK, WPA/WPA2-Enterprise, and Dynamic WEP 802.1x
Support 5 types of WAN connection modes, including STATIC (fixed IP),
DHCP (Auto config), PPPoE (ADSL), L2TP, and PPTP
Support remote access control
Support firewall functions, including IP/MAC/port filter, URL filter, and Web
content filter
Support system status display
Support backuping and restoring configuration file
Ethernet provides cross-over cable detection and also provides auto
modification and polarity modification function
Support system log

1
1 Overview
Thank you for choosing GETNET GR-534W.
GETNET GR-534W is fully compatible with 802.11g standard. Meanwhile, it is also
compatible with 802.11 standards and earlier 802.11b standards. GETNET GR-534W
supports CCK and OFDM and its data rate is up to 150 Mbps. It is easy to install and
can be applied to AP and router access.
GETNET GR-534W provides 64-bit and 128-bit WEP encryption schemes, and WPA
encryption, associating with IEEE 802.1X authentication, which insures the security
of wireless communication.
Package List
Please check whether your package list includes the following items:
GR-534W x 1
Power adapter x 1
RJ 45 cable x 1

2
2 Hardware Description and Hardware Installation
2.1 Front Panel and LED Status
There are 8 LED indicators on the front panel of GR-534W. By observing their
status, you can judge whether the device runs normally.
The following table describes the LED indicators on the front panel.
LED
Indicator Color Status Description
Red On Power is on.
Green On The device runs normally.
- Off Power is off or the device is down.
Green On Radio switch is turned on.
Green Blink Data is being transmitted.
- Off Radio switch is shut off.
WPS Green On Connection succeeds under Wi-Fi
Protected Setup.

3
Green Blink Negotiation is in progress under Wi-Fi
Protected Setup.
- Off Wi-Fi Protected Setup is disabled.
WAN Green On Connection succeeds.
Green Blink Data is being transmitted.
- Off No WAN connection.
LAN
1/2/3/4 Green On LAN connection succeeds.
Green Blink Data is being transmitted.
- Off No LAN connection.
2.2 Rear Panel and Interface Description
The following table describes the interfaces or the buttons on the rear panel:
Interface/Button Description
RESET Press the button for 3 seconds and
then release it. System restores the
factory default settings.
ON/OFF By pressing the button, the power is
on. Press the button again, and then
the power is off.
POWER Power socket, for connecting the
power adapter.
WAN WAN interface, for connecting WAN or
the uplink network devices.
LAN1~LAN4 LAN interface, for connecting hub,
switch, or computer on LAN.
WPS This button is used for enabling WPS
PBC mode. If WPS is enabled, press
this button, and then AP starts to

4
accept the negotiation of PBC mode.
Note:
Do not press the Reset button unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to restore the
default settings, please press the Reset button gently for 3 seconds with a fine
needle inserted into the hole and then release the button. The system reboots and
returns to the factory defaults.
Warning:
The power specification is 12V, 500 mA. If the power adapter does not match the
specification, it may damage the device.
2.3 Hardware Installation
2.3.1 System Requirements
Before installing the device, please make sure that the following items are ready.
At least one Ethernet RJ45 cable (10Base-T/100Base-T)
GR-534W x 1
A PC has been installed PCP/IP protocol and it can access the Internet.
2.3.2 Before You Begin
Before you install the device, please pay attention to the following items:
When connecting the device to the computer, hub, router or switch, the
Ethernet cable should be less than 100 meters.
Do not place this device on an unstable surface or support. Do not put this
device on the ground.
Keep the device clean. Avoid the device from direct sunshine. Avoid any
metal in the device.
Place the device in the center of the area, and try to optimize the wireless
coverage.
2.3.3 Connecting AP
Step 1 Connect one end of the RJ45 cable to the LAN interface of the GR-534W.
Step 2 Connect the other end of the RJ45 cable to your PC.
Step 3 Connect the power adapter to the power socket of the GR-534W.

5
2.4 Operation Range
The operation range of GR-534W depends on the actual environment. When the
device is placed in the house or in the office, the overall arrangements are different.
So the path and effect for the signal transmission are different. For example, the
outdoor straight transmission distance for some devices in the open air is up to 300
meters, and the indoor straight transmission distance is up to 100 meters.
2.5 Roaming
Suppose that several GR-534Ws run in the same network. Each GR-534W acts as
one BSS, and has its coverage. One wireless client terminal (e.g. notebook PC or
PDA) can realize roaming from one AP to another AP correctly. In that case, the
wireless client terminal can communicate with the other devices within the
GR-534Ws’ coverage.
In order to realize the wireless client roaming among different GR-534Ws, you need
to set the GR-534W properly. Do as follows:
Set the same SSID for different GR-534Ws.
The SSIDs of all the computers and PDAs should be consistent with that of
the GR-534Ws.
All the BSSs must use the same wireless channel.
If the encryption function is enabled, all the GR-534Ws should configure
the same encryption mode and the encryption key for establishing
connection.
GR-534W must keep the wireless signal covering the whole operation
environment and the wireless signal should be continuous. Please put the
GR-534Ws to the appropriate places for a better network coverage.