Ghent Harmony Premium User manual

Ghent 2' x 3' Blue Harmony
Glass Markerboard -
Square Corners
Instruction Manual

boards 4'x6' or larger
will include 6
standoffs.
J
K
Board
(Frosted/painted Side
To The Wall)
Marker
Marker/Eraser
Holder
(see note 9)
Eraser
Self-Tapping Screw
(Or Toggle Anchor)
Stand-off
Plastic Flat
Washer
Plastic
Shoulder
Washer
Stand-off
cap
L
IS-HMY 11/14
Harmony Premium Glass Markerboards
Mounting Instructions
For the most secure mounting, the board should be attached
directly into wall studs. Ghent has supplied self-tapping screws
for mounting into wooded wall studs and toggle anchors when
wall studs cannot be used.
We also recommend at least three people install the board.
Install the board with the frosted/painted side facing the wall.
1.)
Place the board up against the wall, at the desired height,
and level the board. Using the holes in the board as a template,
mark the drilling locations on the wall. Set the board aside.
2.)
Insert a self-tapping screw, or toggle anchor, into each stand-
off.
3.)
Drill 3/32" (2MM) holes for the self-tapping screws, or 7/16"
(11MM) holes for the toggle anchors at the marked locations on
the wall.
4.)
Attached the stand-offs to the wall via the self-tapping screw,
or toggle anchors.
5.)
Clean both sides of the board.
6.)
Install the stand-off caps and the plastic washers into the
board as shown.
7.)
Place the marker/eraser holder over the bottom right hand
stand-off.
8.)
Lift the board and align the stand-off caps with the mounted
stand-offs. Swing the marker/eraser holder up into the position
shown and firmly screw the caps into the stand-offs.
9.)
Complete the assembly by loading the markers and eraser
into the marker/eraser holder as shown.
(Note: Not all Harmony Premium Glass boards come with the pictured hardware).
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920