ASSEMBLY INSTRUCTIONS
13. Then, from the 3rd attached cord, count around the jump mat 16 loops and repeat
steps 1-3 to attach the 4th cord. Numbers on the picture above show the approximate
positions of the first 8 suspension cords. Continue connecting the remaining cords as
shown in steps 1-3, but always connect a cord, and then switch to the opposite side of
the trampoline to connect the next cord. Attaching the cords in this manner is
important, as it will ensure even-tension around the entire jump mat. As you work, keep
the enclosure mesh gathered to the center of the mat.
14. Lay the pad cover. Logo printed side up over the suspension cords. Carefully position
each of the 6 openings in the pad cover over their corresponding enclosure pole
sockets, as shown.
15. Carefully work the lower mesh skin (attached to the pad cover) down, around the
entire perimeter of the trampoline, on the outside of the legs.
16. Align the grommet attached to the bottom of the lower mesh skirt with the hole
near the base of the leg and secure with screw. DO NOT OVER TIGHTEN.
17. Repeat Step 9 with the remaining 5 grommets in the lower mesh skirt and their
corresponding legs.
18. Insert the smaller diameter and of an upper enclosure pole into the larger diameter
end of a lower enclosure pole and align screw holes. (You may need to slide the pre
installed foam sleeves to gain access to the end of the poles).
19. Insert screw & tighten. DO NOT OVERTIGHTEN! Repeat steps 1&2 to assemble
remaining 5 sets of upper & lower poles.
20. Insert the bottom end of enclosure pole assembly into the socket on frame, as
shown. Align screw holes.
21. Insert screw & tighten. DO NOT OVERTIGHTEN! Repeat step 3 with the remaining 5
enclosure pole assemblies.
22. Locate the 6 nylon patches with grommets that are sewn onto the top edge of the
mesh. Select a nylon patch that alligns with a pole. Carefully slip one of the patches over
the top of the enclosure pole so that the grommet is alligned with the screw hole in the
pole. Use care so that you do not tear the mesh.
23. Insert screw & tighten. DO NOT OVER TIGHTEN! Repeat step 5 with the remaining 5
patches and poles. When done properly, the enclosure mesh will be hanging on the
INSIDE of the enclosure poles. The mesh should hang down somewhat straight and not
“twist”.
24. Locate the upper and lower sets of hook and loop fasteners sewn to the enclosure
mesh. There are 6 upper and 6 lower sets of hook & loop fasteners.
25. Tightly wrap both the upper & lower hook and loop fasteners around the enclosure
pole foam to secure the mesh in place. Repeat this with the remaining upper and lower
hook & loop fasteners on the other 5 enclosure poles.
8
EN
