GIRtech BASE User manual

Assembly instructions
BASE

GIRtech BASE ASSEMBLY INSTRUCTIONS
The table is delivered disassembled. Each of the component parts is numbered 1 to 9. The
details are shown in the figure.
A complete set contains the following parts:
1. Table construction elements - 6 pcs.
2. Bolt М6х30 - 8 pcs.
3. Bolt М6х50 - 2 pcs.
4. Nut М6 - 8 pcs.
5. Hex key - 1 pc.
SET VIEW
The assembly process comprises of 4 stages and the table can be assembled by one-man.
The table shall be assembled exactly according to the scheme presented below. The assembled
parts are shown in gray. The parts are to be assembled are shown in orange.
Caution! When assembling the structure, keep small parts out of sight of the children as
they can swallow them and choke.

Mount part pos.1 on
a solid surface,
assemble two parts
pos.2 and tighten
bolts pos.6 and nuts
pos.8 with hex key
pos.9

Fasten parts pos.3
with bolts pos.6
and nuts pos.8
using hex key pos. 9

Mount part pos.4,
screw it up with
bolts pos. 6 and
nuts pos.8, using
hex key pos. 9.

Attach part pos. 5
to part pos.4,
tighten it with
bolts pos.7 and
nuts pos.8, using
hex key pos.9

OPERATION MANUAL
The table can be installed on any surface. To do so, adjust the table-legs pos.1 for height.
Rotating the table-leg clockwise or anti-clockwise, you can adjust it for height.

The design envisages 2 positions of part pos. 5 for ease of storage. To remove the
table-flap into the low position, feel for two latches at the joint of details pos.4 and
pos.5
Upholding part pos.5, press the latches and press the part down.