Glacier bay VDR3322A0 User manual

VDR3322A0

B B
BB
Undermount clip (Not including)
If you need to use as under
please buy a similar screw (BB)

4
□Shut off the water supply.
□Insert the faucet body through the hole in the
sink.
5 Securing the faucet assembly
□From underneath the sink, secure the faucet
assembly to the sink with the FastMount™
system (B). Push the FastMount™ system (B)
up over the threads until it stops against the
bottom of the sink, then hand turn (clockwise)
to tighten (Fig 1).
Installing the faucet assembly
Sink Sink
Push
up
Screw
Fig 1
B
B
A
B
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
7 Installing the weight
□Insert the weight (D) onto the clip (E) by sliding
it down onto the clip (E).
□Install the weight clip (E) at the point of the
hose marking “weight here”.
6 Attaching the quick connector
to the receiving block
□
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
1
C
Weight
here
Weight
here
E
D
E
D

8Installing the soap dispenser
□From under the sink, screw the soap bottle (I) onto the
soap assembly (G) shank. Insert the soap pump (F) down
into the soap assembly (G).
□Insert the soap assembly (G) through the selected hole
in the sink. Secure the soap assembly to the sink with
the soap dispenser mounting nut (H) provided.
9
Making the water supply connections
□Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
overtighten.
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging.
1
2
F
G
H
I
Flushing and checking for leaks
□
Pull the hose assembly out of the spout andremove
the spray head by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end of
the hose down into the N sink and turn the faucet to
the warm position where it mixes hot and cold water.
□
Flush the water lines for one minute. This flushes away
any debris that could cause damage to internal parts.
Check for leaks.
□
Re-tighten any connections if necessary, but do not
overtighten. Reinstall the spray head by hand tightening
it back onto the spray hose in a clockwise direction.
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks. Do not lose
the gasket (1) in the hose.
11
Removing the quick connector
□
If it is necessary to remove the quick connector (1),
squeeze the tabs (2) on the quick connector and then
pull down to disconnect.
1
Pull
down
Squeeze
1
1
2

WARNING
When you choose undermount style installation, please do not pull out the installation rail shown as below picture;because
the sink surface would be non repairable damaged after rail pull out. Recommend you could have the professional plumber or countertop or
cabinet seller to install the sink by undermount style.