Gladen ONE 165 Golf 7 User manual

The Crossover:
All cable and clips are assembled, that the clips be used only with the pertinent speakers.
There is the possibility to affect the high-level area by cutting the cable loop on the side.
Important: after cutting these, please isolate them.
Cable loop 1
Series resistance 2,7 Ohm
before the crossover will be
activated after cutting
through
Cable loop 2
Series resistance 3,4
Ohm before the tweeter
will be activated after
cutting through
Possibility of error:
1. tweeter slightly to loud -> cut the blue cable
2. tweeter or voice sizzles -> cut the tranparent cable
RECOMMENDATION: Cutting through the blue cable on the drivers side and the transparent cable on the
passenger‘s side
Installation guide:
The following installation guide is only an example, because there are several different types of the Golf VII with
three or five doors or special edition, furthermore changes in the models as well. Thereby are a lot of variations
possible.
GLADEN ONE 165 Golf 7
Only use this system with an
amplifier that is matched for this
speaker system.
Only assemble this system in this
Plug and Play version. Changes
or increments on the crossover
can cause damage to the
speaker or also can generate a
burning on the speaker.
Never use the speaker without
the crossover – they can be
damaged. This would void the
warranty.
Please consider all instructions
of the vehicle manufacturer and
never make changes, which
effect the vehicle safety.
Listen responsibly. Music played
too loud for extended periods
can cause hearing damage.
Security advice:
AUDIO SYSTEM EUROPE GmbH, Bertha-Benz-Str. 9, 72141 Walddorfhäslach / Germany www .gladen-audio.com

Mounting the Gladen
Woofer-Midrange:
Remove the cover carefully
with a plastic wedge.
The arrows show the Torx 30
screws.
Please remove them all.
At the bottom side there is a
plastic nut M8. For unlock
turn through 90°.
Prise away the door covering
with a plastic wedge. Work
bottom-up.
After that, slide the cover
panel upwards out of the
window seal.
Note:
Clips are strongly fixed.
Now unhook the door
unlocking device.
After that remove all plug
connections and
take the door covering out.

right wrong
!
Before you
assemble the
doorcover please
check, that all clips
are unlocked.
Remove the factory mid bass
driver by drilling out the rivets.
Remove the rest of the rivets
with a 4mm drill bit.
Note:
The rivet can fall into the door
– take care!
Use a tape to avoid.
Mount the speaker adapter
with rivets on the
door plate.
Apply sealant on the speaker
adapter between adapter and
door plate.
To avoid wetness, please glue
a strip of Alubutyl above the
speaker on the speaker
adapter.
Before you assemble the
midrange on the adapter ring,
it must be connected with the
enclosed connecting cable.
Now you can start with the
final assembly of the door
covering.
Connect all plugs with the
door cover. Replace the door
unlocking device, push the
door covering in the window
seal and place it so the clips
can engage.
Don´t forget to fasten again all
screws on the right places.

Mounting the Gladen
Tweeter
Remove the A-pillar covering
carfully with a plastic wedge.
Work top-down.
After that you can slide up and
take out the A- pillar.
Now remove the tweeter by
cutting offthe 3 plates.
Glue the Gladen tweeter
in the window cover (black
arrow).
Plug the cable in the destined
fitting (white arrow).
Connect the crossover with the
plug & play connector of the
high-pass side car connection
and the GLADEN tweeter. After
fix it with cable ties behind the
A-pillar.