GLD Viper 37-0136 User manual

Wall Mounting Assembly Kit
Item #: 37-0136
by GLD PRODUCTS
Great Lakes Dart Mfg., Inc.
S84 W19093, Enterprise Drive
Muskego, WI 53150 USA
[phone] or [phone]
[email protected]
www.gldproducts.com
All trademarks whether or not designated by ™ or ® are owned
by Great Lakes Dart Mfg., Inc. unless otherwise noted.
If your product is missing parts, please call
Customer Support at [phone]
or email [email protected]
CAUTION! CHOKING HAZARD: THIS PRODUCT
INCLUDES SMALL OBJECTS NOT SUITABLE FOR CHILDREN
UNDER 3 YEARS OLD.
CAUTION! BEWARE OF ELECTRICAL WIRES AND WATER
PIPES WHEN DRILLING THROUGH YOUR WALL.

1. Begin by marking o the proper height from the oor on your
wall (5’8” or 1.73m). The bottom of the u-shaped channel should
be at this height. (4’6”or 1.37m for wheelchair user).
3. Drive the Dartboard Mounting Screw into the pre-drilled
center hole, leaving space to hang the dartboard onto the
Mounting Bracket.
2. Apply the Mounting Feet to the backside of your dartboard,
spaced evenly around the perimeter, driving the Stabilizer
Screws into the proper spots.
4. Use the two Bracket Mounting Screws to install the Mounting
Bracket to your wall, using wall anchors if not positioned over
a stud.
5. Place the dartboard onto the Mounting Bracket and check for
tightness against the wall. If the dartboard is wobbling, remove
and tighten or loosen the Dartboard Mounting Screw as needed.