The flexible tube connecting the cylinder to the Built-in-Hob
should be gas resistant and of an approved brand. It should not
be longer than a meter and should be kept away from any
source of heat. The tube should not be subjected to external
pressure, twisted or sharply looped.
When the Built-in-Hob is not in operation ensure that the
regulating knobs on the Built-in-Hob are in the `OFF´ position
and the regulating valve on the cylinder is `CLOSED´.
If the hob requires electrical connection, plug the cable at the
back of the unit. Earth the green/yellow coated cable.
The Built-in-Hobs are provided with integrated auto ignition. Just turn the knob to put on the
flame. As a safety factor the spark will be `ON´in all the burners.
The Built-in-Hob are fitted with European style sealed burners are designed for slow cooking.
Although the glass used in the product is toughened (tempered) but it is not unbreakable,
therefore it should be handled carefully. It may break because of exposure to sudden
extreme temperatures, impact, due to sudden fall of a heavy or pointed object and certain
kind of stresses. In the unlikely event of breakage of glass please note that it is not
covered under warranty and will be replaced on payment basis only. The company will not
be responsible for injury or damage to any person(s) or property as a result of the
breakage of the glass.
During cooking, ensure that the ingredients being cooked do not overflow, which may
extinguish the flame or choke the burner ports.
Before igniting the burners ensure that the burner and cover are properly placed in position. If
they are not kept properly the burner might get deformed. (such deformation is not covered
under warranty).
In case of leakage of gas or any other defect, report to your gas dealer and get the Built-in-Hob
checked/ rectified by an authorised person only.
Use a damp cloth to clean your Built-in-Hob.
The Built-in-Hob has burners of different sizes to save fuel, use the burner which is the most
appropriate to the pan size.
Before carrying out any cleaning operation disconnect the appliance from the electric mains
and turn off the main tap which supplies the appliance with gas. The burner heads, enameled
steel grills, enameled lids and flame dividers must be cleaned periodically with warm soapy
water, rinsed and dried well. Any liquid which overflows from the pan must always be removed
with a cloth.
Make sure that there are no inflammable near the Built-in-Hob.
When the Built-in-Hob is in use check from time to time that it burns normally.
The paint of pan supports will burn off from the tips which are in constant touch with the flame
in the first few hours of cooking.
The burner covers are vitreous enameled and will tend to loose the colour and shine after some
use. Also in case some cold liquid spills, while these covers are very hot, the vitreous enamel
may develop some cracks. This will not be covered under warranty.
The Built-in-Hob is designed for the use with LPG and converting it to natural gas may effect the
efficiency of the burners and the auto ignition.
INSTRUCTIONS FOR USE
Cut an opening into the work surface, as per the
measures W1 x D1 provided in the specifications table.
In order to prevent liquids from accidentally leaking into
the kitchen unit underneath, the appliance is equipped
with a special seal. Stretch out the seal along the edge of
the opening, taking care to overlap the joining points.
Insert the hob into the opening in the work surface.
With a screwdriver assemble the plate A with the special
screw B
Auxiliary burner
Semi-rapid burner
Rapid burner
Triple ring burner
Front left burner knob
Front right burner knob
Back left burner knob
Back right burner knob
Side burner knob
Centre burner knob
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
INSTALLATION
IDENTIFY YOUR BUILT-IN-HOB
1
3 4 2
275 6810
4 2 3
5 610
4
3
2 5 97
22
21
4 5 687
2
3 4 2
175 6810
34
5 97
1
22
4 5 687
GL 1060/1064/1074
3
22
4 5 687
GL 1094 TR
GL 1063 TR GL 1073 TR GL 1075 TR
1
2 4 2
375 6810
GL 1091 MXT / 1095 TR
3
12
4 5 687
GL 1092 MXT
GL 1060 TR GL 1063 MXT GL 1070 MXT
