Global Solutions GS1680 Series User manual

Physical Address: Corporate HQ
301 Meuse Argonne | Hicksville, OH 43526
800.782.6761 • 419.542.7751 • f: 419.542.6690
Global Solutions Distribution Center/Test Kitchen
4300 E Magnolia Street | Phoenix, AZ 85034
October 13, 2020
globalsolutionsfoodequipment.com
OPERATING INSTRUCTIONS
Introduction :
1. Please read instructions before using this appliance.
2. When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock and
injury.
3. Clean machine thoroughly before and after each use following
the cleaning instructions provided below.
4. Electrical Requirements :
Plug unit into a grounded outlet with correct voltage and
sufficient power capacity. Refer to the product label (serial
plate) on the unit for voltage and wattage requirements.
Operation :
1. Plug cord into grounded electrical outlet of the correct
voltage.
2. When properly connected, the induction cooker will
beep once and the light above the ON/OFF buttonwill
blink, indicating power has been applied to the unit. If
the power indicator light is not illuminated and the unit
is plugged in, check the power cord connection.
3. Place suitable cookware onto the cooking surface.
The cooktop surface will not heat up if the wrong type
of cookware is used or there is no cookware on the
surface. Never place empty cookware on the cooker.
4. Set HEAT, TEMP and if desired, TIMER.
A. Press the ON/OFF button one time. The HEAT
indicator light will begin flashing.
B. Press FUNCTION. Toggle between HEAT,
TEMP and TIMER settings. The light indicator
next to each function will illuminate to indicate
which function is ready to be set.
C. Set HEAT. (Heat is the amount of power in watts
applied to the cookware.)Use the UP or DOWN
buttons to set HEAT, the default power of heating
is 1200W. Adjust the power from 500W –
1800W.
D. Set TEMP. Use the UP or DOWN buttons to set
TEMP, the default temperature is 200°F. Adjust
the temperature from 140°F –460°F.
Portable Countertop
Induction Range,
Heavy-Duty
Model Series:
GS1680
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Warning! All power must be disconnected at power source
before any service procedure is performed.
2. This appliance is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials, such
as drapes and other furnishings, away from appliance.
3. Extreme caution is necessary when any appliance is used by
or near children and whenever the appliance is left unattended.
4. Always unplug appliance when not in use and before cleaning,
adjusting, or maintaining this machine. To disconnect appliance,
turn controls off and remove plug from power source.
5. Do not operate any appliance with a damaged or altered cord
or plug, after the appliance malfunctions, has been dropped, or
damaged. Return appliance to an authorized service facility for
examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors. This appliance is not intended for use in
wet or moist locations. Never locate appliance where it may fall
into water.
7. Connect to properly grounded outlets only. Avoid the use of
extension cords. Do not run cord under carpeting, runners, or the
like. Arrange cord away from traffic area and where it will not be
tripped over.
8. To reduce the risk of fire, it is recommended that the unit is
placed on a non-combustible surface.
9. This appliance has electrical parts. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
10. Do not heat an empty pot.
11. Dn not place metallic objects on the cooking surface.
12. Maintain a minimum of 1” space around the cooking unit.
13. Do not block air intake or exhaust vent.
14. Do not touch the cooking surface immediately after removing
a pan; it will still be hot.
15. Do not place cooking unit close to objects that are affected by
magnets.

Physical Address: Corporate HQ
301 Meuse Argonne | Hicksville, OH 43526
800.782.6761 • 419.542.7751 • f: 419.542.6690
Global Solutions Distribution Center/Test Kitchen
4300 E Magnolia Street | Phoenix, AZ 85034
October 13, 2020
globalsolutionsfoodequipment.com
E. Set TIMER. Use the UP or DOWN buttons to set
TIMER. Adjust the time from 0 –180 minutes in
increments of 5. (Press the UP/DOWN buttons
repeatedly to set the TIMER. Or to move quickly
through the timer, press and hold the UP or
DOWN button. If the TIMER is not set, the
induction cooker will function in ON mode for up
to two hours.
5. Timer ON. In order for the timer to be running, TIMER
indicator light must be illuminated. Use the
FUNCTION key to navigate to the time selection and
select a time. Once the desired time has been
selected, let the cooker time and indicator lights blink
until they stay illuminated on their own with no
blinking. The timer is set. The induction cooker will
shut off automatically after the TIMDER reaches “0”.
The cooktop will power down, the fan will cool the
units and shut off. Repeat operations 1-4 to turn the
cooker back on.
6. Turn OFF the cooker and or disconnect power to the
unit after use. After cooking/warming is complete,
press the ON/OFF button to turn off the unit. The
cooker will stop heating the fan will cool the unit down
and will shut off. The power indicator light will remain
illuminated. As long as the ON/OFF indicator light is
illuminated, there is power flowing to the unit. Unplug
the induction cooker completely to disconnect the
power to the unit.
Utensils :
1. Use steel, cast iron, enameled iron, stainless steel
flat-bottomed pans/pots with diameter from 5” –10”.
2. Do not use heat-resistant glass, ceramic, copper,
aluminum pans/pots or round bottomed pans or pans
with bottom diameter of less than 5”.
Cleaning :
NOTE: Proper maintenance plays an important part in the
life span and functioning of the unit.
1. Unplug the cord and let unit cool before cleaning or
moving.
2. Do not use benzine, thinner, scrubbing brush or
polishing powder to clean the induction cooker.
3. Wipe using mild dish washing cleaner and damp
cloth.
4. Do not immerse in water or other liquid. Do not clean
with a water jet.
REPAIR :
To avoid serious injury or damage, do not repair the
induction cooker or replace a damaged power cord
yourself. Repairs must be coordinated through: Global
Solutions customer service at 1-800-782-6761.
TROUBLESHOOTING
E01
Induction cooker
overheats
Clear all obstacles that block the vent under the bottom of the
induction cooker, then placed the cooker in an open area and
try again after the unit cools down.
E03
Voltage under
load/over load
Make sure the voltage and frequency comply with the rating
label shown on the product.