Glos GAMBO Series User manual

INSTALLATION MANUAL
Important Notes and Safety Instructions
Please read installation manual carefully before commencement of installation.
Before carrying out any installation, ensure all power is switched off and disconnected from
the main power supply.
This product must be installed by a qualified installer under local and national regulations.
The light source of the luminaire is not replaceable. When the light source reaches its end of
life, the whole luminaire shall be replaced.
Product Warranty
For any warranty claim, a valid Proof of Purchase is required.
Glos does not warrant any claim based on defects or damage caused by improper
installation, improper operation, wrongful cleaning agents that deteriorate the surface
appearance, force majeure, and/or modifications made by purchaser or third party. For
warranty duration, please contact your service agent or GLOS sales representative for
more information.
Cleaning and Care
Before cleaning, disconnect the luminaire from main supply and allow it to cool. Clean
external surface using lint free cloth with alcohol-free and non-abrasive cleaning agent.
Corrosion Protection
Do not expose luminaire to corrosive agents (e.g salt, acid, chemical & cleaning agents)
during installation or cleaning, it will cause corrosion on the surface of the luminaire.
Ambient Condition
LED luminaires performs best in an ambient temperature <25°C (+-5°C). High ambient
temperature can reduce the lifespan and efficiency of LED module and driver.
Dimming
Before installation of luminaire, ensure control gear, LED and dimmer combination are
compatible. Improper or unsuitable use of dimmer can cause damage to the components.
Sizing Variation
Product A B
GAMBO 107 83
GAMBO
SERIES
AB

1
43
2
Installation Instructions Before installation or servicing, turn off and disconnect from main power supply. If
the external core cable of this luminaire is damaged, it shall be replaced by the
manufacturer, service agent or a similar qualified person to avoid a hazard.
Attach luminaire to spike and use the allen key provided to tighten the bolt on the
luminaire. Please do not over-tighten the bolt.
Mount luminaire in desired location by using the foot-step ground spike. Position IP
box away from the areas where they may be at risk from being cut, trapped or
damaged. Ensure all electrical connection are fully tightened before use.
To adjust the angle of the luminaire, loosen the bolt and tilt to the desired angle.
Tighten bolt after adjusting. Restore power.
1
2
3
4
INSTALLATION MANUAL
www.glos.com.sg
1
OFF
ON
2
1
OFF
ON 2
4
1Note: while installing the
front cover, please attach
the frontcover to the main
body tightly.
2
31
2
Stamp it
Note: to ensure long life span during
operation, please prepare IP67 housing
or relevant connector to connect external
cable from luminaire to power supply.
AC 220-240V 150°
Please loose the screw when adjust the
position of the fixture.Please fasten the
screw after adjusting a suitable position
of the fixture.