GPX TM65 User manual

FULL MOTION FLAT PANEL TV MOUNT FOR 28-65”TELEVISIONS
User’s Guide for Model TM65 v1568-01
! x6
STEP 1
Level and Pre-drill Holes for Mount
• Usetheincludedleveltoensurethemountiscorrectlyalignedand
square,thenmarkholesfordrilling.
• Drill6holesforthemounttoattachtothewall.Onlydrillintoasolidwall,
orthewoodenstudsbehinddrywallorsheetrock.
• For drywall and studs,usea5/32”drillbit.
• For solid/concrete walls,usea3/8”or10mmdrillbit.
! x6
WARNINGS
• THE TV MOUNT MUST BE FIRMLY ATTACHED TO A SOLID CONCRETE/
BRICK/WOOD WALL, OR WALL STUDS BEHIND DRYWALL.
• Tightenscrewssothatpartsarermlyattached,butdonotovertighten.
Overtighteningmaycauseunintendeddamageorweakeningofparts.
• Donotremoveorloosenanyscrewsuntiltheyarenolongerengaged
withthemount.DoingsomaycausetheTVtofall.
• Itishighlyrecommendedtohavethismountprofessionallyinstalled.
• Supports VESA up to 600 x 400mm.
• This mount is designed to hold a maximum of 132 lbs (60 kg).
TOOLS
Thefollowingtoolsarerecommendedforthisinstallation:
• Drill
• 5/32”drillbitfordrywall
• 3/8”or10mmdrillbitforconcrete
• Studnder
• Phillipsscrewdriver
PARTS
x2I M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50 x6K
Ø10x50 x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5
x4G
x2I M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50 x6K
Ø10x50 x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5 x4G
Note: Parts A-G are used to attach
your TV to the brackets in Step 3,
but you will not need all of them. Use
the set that best ts your TV.
STEP 2
Attach Mount to Wall
• If mounting to a solid wall,
insertthesixwallanchorsintothe
holesdrilledinStep1,thenscrew
thebaseplatermlytothewall
withthesuppliedscrews.
• If mounting to drywall/studs,
screwthebaseplatermlytothe
wallwiththesuppliedscrews.
• We recommend drilling 4 holes at the top of the mounting plate,
and 2 at the bottom.
x2I M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50 x6K
Ø10x50
x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5 x4G
x2I M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50
x6K
Ø10x50 x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5 x4G
K
J
Towards Wall

FULL MOTION FLAT PANEL TV MOUNT FOR 28-65”TELEVISIONS
User’s Guide for Model TM65 v1568-01
• Attachthetwobracketstothe
rearofyourTV,hooksdown.
• Usetheincludedscrewsand
washers(PartsA-G)tosecurethe
brackettoyourTV.Findtheset
thattsyourTVanddiscardthe
rest.
• Therubberwashers(PartG)can
beusedasaspacerbetween
the TV body and the mounting
brackets, ifthemountingholes
ontheTVaretooshallowforthe
includedscrews.
STEP 4
Attach Television to Mount
ARTICULATION & RANGE OF MOTION
• AttachtheTV/brackettothemountonthewall,makingsuretormly
tightenthelowernuttothemounttosecuretheTV(donotovertighten
ordamageresult).
• ItishighlyrecommendedtouseatleasttwopeopletohangtheTV.
N
!
H
Optional Screws
& Washers
Tighten screw to secureTV brackets to mount
Make sure brackets are
hooks down
I
A-G
STEP 3
Attach Brackets to Television
PARTS A-G
!
center to center
MAX 600mm
180˚
MAX
400mm
8˚ up
12˚ down
643mm
x2I M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50 x6K
Ø10x50 x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5 x4G
x2I M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50 x6K
Ø10x50 x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5 x4G
x2I
M6x38
x4F Ø8
Ø5 x4D
H x2
M6x20
x4C M5x15
B x4
M6x15
A x4
M8x15
M6x50 x6K
Ø10x50 x6J
x4E Ø6
x1M
N x2
x1L Level
Ø15xØ8x4.5 x4G