IV-O2 Holder Installation Instructions
B10320E-IRevision B Graham-Field Health Products, Inc., June 2005 3
Lock IV hanger in place with bolt
Tools needed: Needlenose pliers,
Phillips screwdriver,
7
/
16
" wrench
You may wish to use bolts, rather than button
locks, to secure either or both of the two locking
positions shown in the picture at right. The
following instructions will explain how to disas-
semble the IV hanger from the intermediate tube,
then reassemble in locking configuration: You will
remove the IV hanger from the intermediate tube,
remove the button lock from the IV hanger,
reinstall the IV hanger in the intermediate tube,
and install the bolt and nut to secure and lock IV
hanger and intermediate tube into place.
1. Depress button lock until IV hanger slides
inside intermediate tube; lift IV hanger out
from intermediate tube.
2. Remove button lock from IV hanger: Depress
button while holding button lock with
needlenose pliers, as shown in picture at right.
Remove button lock from IV hanger.
3. Insert IV hanger into intermediate tube; slide
IV hanger inside intermediate tube to desired
height position, so that appropriate holes are
aligned, as shown in picture at lower right.
Insert bolt through both IV hanger and
intermediate tube as shown.
4. Install nut on bolt. Use Phillips screwdriver
and 7/16" wrench to tighten nut until IV
hanger, intermediate tube, bolt and nut are
secure.
5. If you wish to lock intermediate tube in place
in O2 holder (lower locking position), follow
steps 1-4 to remove lower button lock and
install bolt and nut.
WARNING: Do not use IV-O2 Holder unless assembled as described. Ensure that all
components are securely installed before use.
locking
positions
IV hanger
intermediate
tube
O2
holder
locking
positions
remove
button lock
button lock
button
IV hanger
install
bolt and nut
bolt
nut
IV hanger
intermediate
tube
