3
1 Safety
1.1 Introduction
The assembly and operating instructions are part of a mower rack.
No liability is accepted for personal injury, damage to the work equipment and the rack, which is caused by failure
to comply with these operating instructions.
The following safety instructions are intended to help prevent personal injury and damage to property. For your own
safety, it is absolutely necessary to observe the safety instructions in this operating manual. In addition, the appli-
cable national and international safety regulations of the responsible authorities for occupational safety and accident
prevention must be observed. Each operator is responsible for complying with these regulations.
1.2 Safety regulations for commissioning
The rack is approved for installation and use in dry rooms only. Use in damp and wet rooms as well as in rooms
subject to explosion hazards is not permitted.
1.3 Safety regulations for operation
The operating instructions must be accessible and must be observed by every user. The legal regulations for acci-
dent prevention must be observed. Statutory provisions and regulations have priority over the operating instructions.
Use only as intended. The specified payload must not be exceeded.
Persons may not be transported with the rack. Climbing up the rack is also prohibited.
The racks are intended exclusively for loading and unloading by hand.
Not intended for storage of food products.
The correct functioning of the safety devices must be checked regularly. If there are irregularities in the safety
devices, the rack must not be used.
Any liability of the manufacturer is excluded if safety instructions and/or respective legal regulations are not ob-
served.
ATTENTION! Do not drive the rollable rack over uneven surfaces or bumps, door thresholds or sloping ramps.
The rack could tip over!
Generally applicable laws, standards and regulations must be observed.
1.4 Safety devices on the rack
Swivel castors with parking brake: Brake must be in the locked position in order to secure the rack against
movement.
1.5 Rack Inspection
A rack inspection is a regular check of commercially used shelves. Since unintentional damage can occur during
loading and unloading of shelves, the shelving inspection is meant to identify these damages. The purpose of a
rack inspection is to prevent accidents. According to the Industrial Safety Regulation, the employer is responsible
for the safety of his storage facilities. Shelves must be inspected by a competent person at least every 12 months.
1.6 Environmental information / disposal
Old and defective components as well as the packaging materials can be separated according to type so that they
can be disposed of in an environmentally friendly manner or recycled as required.
