Green Brook Powerbreaker J62-T Manual

INSTALLATION/OPERATING
INSTRUCTIONS FOR 16 AMP
230V IN-LINE PORTABLE RCD
MODEL NUMBER: J62-T
PowerBreaker J62 is a two pole in-line
portable RCD, designed for use in
commercial and industrial environments
where rough handling is expected.
The water resistant casing of the unit is
rated at IP 6 (BS 420, IEC 144).
This product should be wired with
1. mm23 core flexible cable (BS6 00).
Connect cable to the input and output
terminals, ensuring that the following is
observed.
• Live/Brown to Brown wire terminal
• Neutral/Blue to Blue wire terminal
• Earth Green/Yellow to Green/Yellow
Terminal
Ensure that there are no loose strands of
wire. To ensure the IP rating, terminals
and cover should be sealed with the
supplied sealant.
• When fitting plugs, sockets or
connectors follow the accessory
manufacturer’s instructions ensuring
that the live, neutral and earth (if
any) cores are connected correctly
and the outer covering of the cable
is firmly secured.
• The plug on the appliance should
be fused in accordance with the
appliance manufacturer’s
instructions.
• To maintain the IP 6 weather proof
rating of the device, plugs, sockets
and connectors of an equivalent
rating must be used.
Please carry out the simple test
procedure prior to each use.
• Insert plug into power socket outlet.
• Press and release reset button -
the red indicator should appear in
the window.
• Press the test button - the red
indicator should disappear.
This means the RCD has tripped
successfully, cutting off the power
from the RCD.
• Now press and release the reset
button again, the unit is ready for
use.
WIRING
IMPORTANT
INSTRUCTIONS

If the red indicator fails to work as
described above, do not use.
IMPORTANT FOR YOUR PROTECTION
• Electricity is dangerous and an RCD
must not be used as a substitute for
normal precautionary measures.
• Always unplug from mains supply
before any inspection or repair to
equipment.
• Do not allow children to tamper with
electrical devices.
• Should your PowerBreaker
repeatedly trip with an appliance
connected, or fail to trip when
tested, seek advice immediately
from a competent electrician or
return to place of purchase.
• This device will protect against live
and neutral faults to earth. It will
not protect against electric shock
due to contact with both conductors,
short circuits between live and
neutral, or a fault in the wiring
supplying this device.
Rated Voltage: 230V AC
No. of poles: 2
Rated Current: 16 Amps
(4 Amps Inductive load)
Frequency: 0/60Hz
Rated tripping
current: 30mA
Environmental
protection rating: IP 6
(BS 420 / IEC 144)
The PowerBreaker Safety In-line Portable
RCD has been designed for storage and
use between - ºC and +40ºC at an
altitude no greater than 2000m above
sea level. Care must be taken not to
subject your PowerBreaker to abnormal
pollution by smoke chemical or
flammable fumes, salt laden spray,
prolonged periods of high humidity,
immersion, repeated dropping, or any
other abnormal conditions.
TECHNICAL SPECIFICATION
GUARANTEE
Your PowerBreaker 16 Am In-line
Portable RCD is guaranteed
for 12 months.
Each unit is individually tested before
leaving the factory.
WARNING
PLEASE KEEP THESE INSTRUCTIONS
SAFE FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
[email protected]
WWW.GREENBROOK.CO.UK
Issue No: 701474