
Model Num er: J63-X
PowerBreaker J63-X is a two pole in-line
portable RCD, with built in IEC connectors for
easy fit, and quick release from the
appliance. Ideal for use in commercial and
office environments.
This unit should e installed to current IET
wiring regulations if in dou t consult
a qualified electrician.
The incoming end of the in-line RCD has the
built in IEC connector in the housing, and must
be connected to the mains supply.
The outgoing supply has a 0.3 metre length of
cable, which is fitted with an IEC plug.
It is essential that the unit is connected the
right way round i.e. with the built in plug end
connected to the mains supply.
When used with other accessories, ensure that
the fuse or MCB protecting the circuit has the
correct rating.
Please carry out the simple test procedure
prior to each use.
• Insert plug into power socket outlet.
• Press and release reset button -
the red indicator should appear in the
window.
• Press the test button - the red indicator
should disappear.
This means the RCD has tripped
successfully, cutting off the power from the
RCD.
• Now press and release the reset button
again, the unit is ready for use.
If the red indicator fails to work as described
above, do not use.
IMPORTANT FOR OUR PROTECTION
• Electricity is dangerous and an RCD
must not be used as a substitute for
normal precautionary measures.
• Always unplug from mains supply before
any inspection or repair to equipment.
• Do not allow children to tamper with
electrical devices.
• hould your PowerBreaker repeatedly
trip with an appliance connected, or fail
to trip when tested, seek advice
immediately from a competent
electrician.
• This device will protect against live and
neutral faults to earth. It will not protect
against electric shock due to contact with
both conductors, short circuits between
live and neutral, or a fault in the wiring
supplying this device
WIRING
INSTRUCTIONS
Installation/Operating Instructions for
10 Amp 220V / 240V
In-line Portable RCD
WARNING
IMPORTANT
Note:
The PowerBreaker Safety In-line Porta le RCD
has een designed for storage and use
etween -5°C and +40°C at an altitude no
greater than 2000m a ove sea level. Care
must e taken not to su ject your
PowerBreaker to a normal pollution y smoke
chemical or flamma le fumes, salt laden
spray, prolonged periods of high humidity,
immersion, repeated dropping, or any other
a normal conditions.
J63-X Ins Sept 21.q p_J62-T 08/09/2021 16:00 Page 1