Green Star LUNA User manual

GSSA | Company Confidential
Page 1 of 2
Document Name
LUNA Installation Instruction
Template Number
GSPDPAD46
Document Number
PDPAD460000692
Document Owner
ESS Department
Template Rev
01
Document Rev
AA001
BEFOREYOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
WARNING
Risk of electrical shock. Disconnect power before
servicing or installing luminaire.
WARNING
Risk of injury or damage. Luminaire will fall if not installed
properly. Follow installation instructions.
WARNING
Risk of injury. Wear safety glasses and gloves during
installation and servicing.
Important Notice
These instructions are not intended to cover all details or variations
in the products nor do these instructions provide for every possible
contingency concerning the installation, operations, or maintenance
of the luminaire. Should additional information be required, contact
your Greenstar Products Inc.
The contents of this manual shall not become a part of or modify any
prior or existing agreement, commitment, or relationship. The sales
contact contains the entire obligation of Greenstar Products Inc.’s
standard limited warranty is the sole warranty obligation of Greenstar
Products Inc. and any statements contained herein do not create
new warranties or modify the existing warranty.
Any electrical or mechanical modifications to the luminaire without
the prior written consent of Greenstar Products Inc. may void all
warranties or other safety certifications. Unauthorized modifications
may also result in safety hazards or damage to the luminaire.
Misuse of the luminaire could result in injury and equipment
damage. In no event will Greenstar Products Inc. be responsible or
liable for direct, indirect, special, or consequential damage or injury
that may result from the misuse of the luminaire.
PRODUCTVIEWS
SIDE VIEW TOP VIEW BOTTOM VIEW FRONT VIEW

GSSA | Company Confidential
Page 2 of 2
Document Name
LUNA Installation Instruction
Template Number
GSPDPAD46
Document Number
PDPAD460000692
Document Owner
ESS Department
Template Rev
01
Document Rev
AA001
Figure a
Inspection
The packaging has been designed to protect the luminaire from damage
during transit. Inspect luminaire for damage before installation.
Mounting the Luminaire
Figure b
Figure c
Top edge of mounting bracket
Bottom edge of mounting bracket
holder
Mount the LUNA mounting bracket to the wall using (8) M4x0.7x45 Socket
head screw with the help of (8) M4 plain washer.(see figure a)
Make the flexible wire connection to the Junction Box suitable for wet
location and in accordance with the National Electrical Code (NEC).
Wiring
o NOTE: Make sure that all electrical connections are in accordance
with the National Electrical Code (NEC), and any applicable local
code requirements.
o NOTE: Check the rated input voltage on the luminaire product label,
and verify that the supply voltage meets the product requirements.
o When making electrical connections, make sure that the ground wire
on the supply side is connected to the ground wire of the luminaire.
Under no circumstances the ground wire should be left disconnected.
This will cause the luminaire to fail, and the luminaire will not be
covered under warranty.
Fasten the luminaire with (2) M6 x 1 x 25 Hex socket set screw cone point
to restrict its movement.(see figure c)
M6 x 1 x 25 Hex socket set screw cone point
Maintenance
Depending on environmental conditions it may be necessary to clean the
lens in order to maintain a high-efficiency lens. (Use solvent-free cleaners)
Remove the conduit and check the electrical connections. Make sure to
conceal the conduit properly to the luminaire.
Storage
Prior to installation, the luminaire should be placed in a covered, dry
storage. The storage location should not exceed the normal operating
temperature of the luminaire.