GreenOn GPS VOICE COACH User manual

1
Failure to heed the following warnings could result in an accident or
medical event resulting in serious injury.
• The device could su󱐯er from interference from external electrical sources.
Important Safety and Product Information
!WARNING
GREENON “GPS VOICE COACH” User’s Manual
・GREENON “GPS VOICE COACH”
・Clip-type charging / communication
・Pendant ring
・Attachment clip
・(Present) User’s Manual
・Warranty card
1unit
1pcs
1pcs
1pcs
1book
1pcs
Package contains
Ver.1.00

2 3
• The data and information provided by the voice coach is an estimation
of your running, but may not be completely accurate, which may include ,
distance, rap time and calorie data.
• A lithium-ion battery can be used in this device. If these guidelines
are not followed, batteries may experience a shortened life span or may
present a risk of damage to the device, re, chemical burn, electrolyte
leak, and/or injury. - Do not leave the device exposed to a heat source
or in a high-temperature location, such as in the sun in an unattended
vehicle. To prevent the possibility of damage, remove the device from the
vehicle or store it out of direct sunlight.
• Do not disassemble, modify, remanufacture, puncture or damage the
device or batteries.
• Do not immerse or expose the device or batteries to water or other
liquids, re, explosion, or other hazard.
• Do not use a power and/or data cable that is not approved or supplied
by GreenOn.
• If using an external battery charger, only use the GreenOn accessory
approved for your product.
• To replacement batteries, see the GreenOn website.
• Do not operate the device outside of the temperature ranges specied in
the printed manual in the product packaging.
• When storing the device for an extended time period, store within the
temperature ranges specied in the manual .
• This product does not contain any user-serviceable parts. Repairs should
only be made by an authorized GreenOn service center. Unauthorized
repairs or modifications could result in permanent damage to the
equipment, and void your warranty.
Before use
Equipment name
Main button (Start measurement / optional
announcement)(Press over 1 second to Power On/ O󱐯)
Button (Volume control, Pause/ resume
measurement)
Pendant ring attachment hole
Charging/ communication terminal
GPS status LED (orange)
Orange light: Searching GPS (unavailable)
Orange light ashing: Receiving GPS (ready for use)
Charging status LED (red / green)
Red light: Remaining battery capacity is small (needs
charging)
Red light ashing: Charging
Green light: Charging completed
Button (Metronome On/ O󱐯)
Clip stopper
Charging clip guide hole
Equipment ID

4 5
Clip-type charging/ communication cable
Guide
Guide
Charging/ communication
terminal
First connect the charging clip to the body, and then connect the USB connector to the PC or a
dedicated AC charger.
※ If the charging / communication terminal disconnects during data communication, data is
no longer written normally and device operation may stop. Please check that the terminal
is surely connected according to the guide hole, before beginning the communication.
Also, connect the USB connector and the clip in a stable location so as not to disconnect
from the terminal by accident during communication, and do not touch until the end of the
communication.
USB Connector
Charging clip
How to charge
①Please open by pinching the charging clip.
②Please hold the main body with the clip so as to insert the
charging clip guide in the main body guide hole.
③Check that the charging clip guide is in the guide hole,
then connect the USB connector to the PC USB port or a
dedicated AC charger.
④A red LED light will ash when charging. Charging takes
about 3 hours.
⑤A green LED will light up when fully charged. Disconnect
the USB connector rst, before removing the charging clip.
After purchase, please make sure you charge the battery before use. When
charging, rst connect the charging clip to the body, and then connect the
USB connector to the PC or a dedicated AC charger.

6 7
How to attach & remove the xing clip
To remove the clip, lift the tip of the bottom side, and slide.
Please insert the xing clip after aligning the hooks and the
slits on the left and right of the main body. Insert until you
hear a click and the clip is xed.
■How to attach
■How to remove
※Please be careful not to hurt your hand.
How to attach & remove the pendant ring
As the pendant ring is screwed on, you will need an
appropriate size cross-slot screwdriver when attaching or
removing it. The ring and screw are very small, so please be
careful not to lose them.
※The screw thread may be stripped and you may not be able to remove
the screw if you use a wrong size screwdriver.
※The screwdriver is not included.
Function settings
1.Connect the computer and the unit with the clip-type
transmission cable.
Starting the setting tools
First please download the setting tools from the GreenOn
home page.Connect this unit to a PC using the transmission
cable, and use the setting tools to set various functions.
www.greenon.jp/running/english
Install the setting tools you have downloaded to your
computer.
Installing setting tools
2.Start the setting tools by double-clicking the "GPS Voice
Coach" icon on the desktop.
※You will be able to use the default settings, even if you do not change the setting. Please refer
to P15 for default values, and to P17 for usage information.
※For more details about downloading and installation method, please check our company
website.

8 9
Start the setting tools to see the setting screen. Please set
according to your usage needs. Below is a list of the items
that can be congured.
Parameter setting of each function
Setting items Setting details Default
value Function details
Basic
settings Weight 10-200lb 60 Set a weight between 10-200lb.
Voice
settings
Auto pause ON/ OFF OFF
Measurement will be interrupted
automatically when the speed is below
1mi/h and will continuation when the
speed is above 1mi/h.
Pace
notication ON/ OFF ON Announces the pace every 0.25mi (time
per 1 mi).
Pace alert ON/ OFF (high/
low speed setting) OFF
If the speed falls outside the set lower
and upper limits, you will hear an alarm
sound
Lap notication OFF/ per 1mi/ per
0.5mi
Per 1mi*
Items set
as default
Mileage*, split time*, lap time*, pace,
calories burned, average pace
Power OFF
notication
Set measurement
items
*Items set
as default
Mileage*, split time*, average pace*,
calories burned*, monthly total mileage,
fastest pace, slowest pace
Optional
notication
Set measurement
items
*Items set
as default
Mileage*, split time*, pace, calories
burned, average pace
Metronome
settings
Continuous
operation ON/ OFF OFF
When set to ON, it operates
continuously. When set to OFF, it rings
for 20 seconds, stops for one minute
and repeats.
Cycle 50-250 times/ per
minute １２０ Sets the metronome cycle (times/ per
minute).
Measurement data can be registered to the web site (Marathon's
World) for data management and evaluation.
For details about use, please check our company website.
www.greenon.jp/running/english
Registering and viewing measurement data
●The supported OS for the setting tools are Windows 10 /
8.1 / 8 / 7 & Vista , but we do not guarantee operation
in all environments. In particular, we o󱐯er no guarantee of
operation in the following types of environments.
・ Home-built PC
・ PC on which the pre-installed OS was changed
・ Virtual machines and Bootcamp for MacOS
・Non-English OS
■Supported OS
※Marathon's World is a GreenOn partner running SNS Web site.

10 11
Once at the starting point, please turn the power ON by
pressing and holding the main button. When the power is
ON, an orange LED light will turn on, and after notication
sound (♪), the following message will be announced.
How to use
Power ON
※Please charge before running.
Welcome to GPS
Voice Coach!
Press and hold
〜♪
(1) Lap notication (automatic announcement of the set
measurement items every 1mi or 0.5mi)
Measured items: mileage*, split time*, lap time*, pace, calories burned, average pace
Key functions * Represents default settings
The LED (orange) light is on
Measured items: mileage*, split time*, pace*, calories burned, average pace
The battery
level is "4".
※The battery level is "2" announcement means that you have
approximately 30 minutes usage time left. (FW1.02 and over)
(2) Optional notication (announcement of set measurement
items when you press the button)
(3)
Pace notication (automatic announcement of your pace every 0.25mi)
(4) Metronome (marks running pitch by sound)
LED (orange)
light ashes
You will also hear the following announcement, and GPS
Search will begin automatically. Please wait in an open sky
area until the GPS signal is received.When the GPS signal is
received, you will hear notication sound (♪) and the following
message will be announced. The LED (orange) light will ash.
Start GPS Search
LED (orange)
light is on
Beginning
GPS Search
※It might take about 10 minutes until the GPS signal is locked (received).Please turn the power
ON to begin receiving the GPS signal before you start running.
〜♪
GPS locked
Before beginning the measurement, press the
button to adjust the volume. There are three
volume levels (the default is level 2). When
you press the button to adjust the volume, you
will hear 3 rings at the selected volume. The
volume level will change each time you press
the button in this order "2→ 3→ 2→ 1→ 2".
Volume control
〜♪
〜♪
〜♪
※After beginning the measurement, you will not be able to
adjust the volume.

12 13
Press the main button to begin the measurement. If you have
set the auto pause to ON in advance on your computer, the
measurement will be interrupted automatically when the
speed is below 1mile/h and will continuation automatically
when the speed is above 1mile/h again.
Start measurement
Beginning
measurement
During measurement, announces lap data for the distance
set in advance on your PC (1mile / half mile / OFF). Before
the announcement, you will hear a lap notication sound (♪).
Lap notication
Distance: 3 mi; split time: 15
minutes and 25 seconds; lap time:
5 minutes and 30 seconds
※Distance is cumulative distance.
※Announcement content can be changed in Parameter settings.
※Pausing and restarting can be done
manually too. Please refer to P●● for
details.
〜♪ 〜♪ 〜♪
During measurement, if the speed falls outside the lower and
upper limits set on your PC, you will hear an alarm sound (♪)
and a pace notication.
Pace alert
Pace: 6 minutes
and 45 seconds
Announces your pace every 0.25mi during measurement.
Before the announcement, you will hear a pace notication
sound (♪). Pace refers to the time required to run 1mi at the
current rate (in minutes). If the setting on your computer is
OFF, there will be no pace announcement.
Pace notication
Pace: 5 minutes
and 20 seconds
〜♪
〜♪

14 15
When you press the main button during measurement, the
running data at that point will be announced.
Optional notication
Distance: 15 mi; split time: 1 hour
50 minutes and 15 seconds
※Announcement content can be
changed in Parameter settings.
When you press the button during measurement, you
will hear a metronome sound in a cycle set in advance on
your computer. Press again to stop.If in Parameter setting
"Continuous operation" is set to OFF, it will ring for about 20
seconds, stop for one minute and repeat.
Metronome
♪P i - P o
♪P i - P o
※The default setting for "Continuous setting" is OFF.
Pausing and resuming measurement
To pause measurement when you are waiting at a tra󱐰c light,
etc., please press the button. Measurement is paused.
Resume: Press the button to resume measurement.
If you have set the auto pause to ON and your running speed is below 1mi/h for more
than 3 seconds, the measurement will be paused, whether you operate the button or
not. When the speed goes above 1mi/h again, the measurement will be resumed.
Measurement
is paused.
Measurement
is resumed.
Power OFF (nish measurement)
To nish the measurement, please press and hold the main
button. After announcing the message below, measurement
will end and the power will turn o󱐯.
Finish measurement. Distance: 15 mi; split
time: 1 hour 50 minutes and 45 seconds;
average pace: 5 minutes and 15 seconds;
calories burnt: 545 kcal. The power will be
turned o󱐯.
Press and hold ※Announcement content can be changed in Parameter settings.

16
How to reset
In case the device does not react when you
press a button, please try to reset. Press the
main button and button together to reset
and turn the power off. Press and hold the
main button again to turn the power on.
Press the main
button &
button together
Size 37 (H) X37 (L) X12.5 (W) mm
Weight 20g (main unit, including battery)
Battery Rechargeable lithium-ion battery
Waterproof performance IPX-5
Operating temperature
range
-10°C~ + 60°C (Charging temperature range: 0°C~ +
45°C)
External interface Clip-type dedicated charging / communication terminal
Continuous operating time About 8 hours (depending on sound usage)
GPS WGS84 datum, DGPS (SBAS) support
Product specications
Contact
For inquiries, please contact: www.greenon.jp/running/english
masa Corp. Service center Postal code: 103-0011
6-8 Odenma-cho, Nihonbashi, Chuo-ku, Tokyo
E-mail：[email protected]