Note: Fits Maximum Bench thickness of 38mm.
To install mixer, cut a mounting hole 35mm in diameter in the bench surface.
1. Unscrew mounting nut and remove steel washer and rubber washer from
threaded mixer tail. Ensure seal is sitting in groove at base of mixer.
2. Position mixer in bench top with hot inlet pipe on the left.
3. From underneath the bench install the rubber washer then the steel washer
and screw mounting nut onto threaded tail of mixer and tighten the jacking
screws.
a. Screws may require backing off before installing nut.
4. Install inlet hoses:
. a. Screw the “HOT” hose (red) and hand tighten into hot inlet (red) of mixer.
b. Screw the “COLD” hose (blue) and hand tighten, into cold inlet of mixer.
5. Connect flexi hoses to water supply.
a. The union nuts must be connected to 15mm thread fittings which have a
machined end face with a chamfer, not “sawn off” threaded tube.
b. Do not over tighten the nuts.
i. Hand tighten then 1/4 turn with spanner.
c. Do not kink, stretch or twist , any bends in the flexible hose should have
radius of no less than 85mm.
6. Turn on water supply and check for leaks.
INSTALLATION INSTRUCTIONS
SINK MIXER
BENCH TOPS
Formica/wooden bench tops, extra mounting support is required below the bench.
Stainless steel bench tops ensure the mounting washer is against the S/Steel.
Vitreous china tops additional sealant maybe required at the base of the mixer
to ensure a water tight seal.
