Gretsch G6163 Executive User manual
®
PART NUMBERS: 2301010100 (120V, 60Hz)
POWER REQUIREMENT: 100W
POWER OUTPUT: 20W RMS into 8Ω @ 5% THD
INPUT IMPEDANCE: NORMAL: 168kΩ
BRIGHT: 2.2MΩ
FUSE: 100-120V VERSIONS: 2A, 125V
DIMENSIONS: HEIGHT: 24 in (61 cm),
WIDTH: 26 in (66 cm),
DEPTH: 11 in (28 cm)
WEIGHT: 50 lb (23 kg)
Product specifications are subject to change without notice.
Specifications
Important Safety Instructions
This symbol warns the user of dangerous voltage levels localized within
the enclosure.
This symbol advises the user to read all accompanying literature for safe
operation of the unit.
∆ Read, retain, and follow all instructions. Heed all warnings.
∆ Only connect the power supply cord to an earth grounded AC receptacle in accordance
with the voltage and frequency ratings listed under INPUT POWER on the rear panel
of this product.
∆ WARNING: To prevent damage, fire or shock hazard, do not expose this unit to rain
or moisture.
∆ Unplug the power supply cord before cleaning the unit exterior (use a damp cloth
only). Wait until the unit is completely dry before reconnecting it to power.
∆ During operation: Maintain at least 6 inches (15.25 cm) of unobstructed air space
around the unit to allow for proper ventilation and cooling of the unit; do not block
any vents in the unit chassis. Also, if rack mounted, remove the rack enclosure front
and rear covers and leave empty one full rack space above the unit.
∆ This product should be located away from heat sources such as radiators, heat
registers, or other products that produce heat.
∆ This product may be equipped with a polarized plug (one blade wider than the other).
This is a safety feature. If you are unable to insert the plug into the outlet, contact an
electrician to replace your obsolete outlet. Do not defeat the safety purpose of this
plug.
∆ Protect the power supply cord from being pinched or abraded.
∆ This product should only be used with a rack, cart or stand that is recommended by
the manufacturer.
∆ The power supply cord of this product should be unplugged from the outlet when left
unused for a long period of time, or during electrical storms.
∆ This product should be serviced by qualified service personnel when: the power
supply cord or the plug has been damaged; or objects have fallen, or liquid has been
spilled onto the product; or the product has been exposed to rain; or the product does
not appear to operate normally or exhibits a marked change in performance; or the
product has been dropped, or the enclosure damaged.
∆ Do not drip nor splash liquids, nor place liquid filled containers on the unit.
∆ CAUTION: No user serviceable parts inside, refer servicing to qualified personnel
only.
∆ Gretsch® amplifiers and loudspeaker systems are capable of producing very high
sound pressure levels which may cause temporary or permanent hearing damage.
Use care when setting and adjusting volume levels during use.
A. FUSE – Protects the amplifier from electrical
faults. Replace a blown fuse only with the type
and rating specified for your amplifier.
B. POWER SWITCH – Switches the amplifier on-
off.
C. STANDBY SWITCH – Put the amplifier into
standby (YIELD), rather than turning the power
off, during short breaks. This eliminates the tube
"warm-up delay" upon returning to play, and it
also extends the life of the amplifier tubes.
D. POWER JEWEL – Indicates when the amplifier
is receiving power.
E. INTENSITY – Controls how apparent the Vibrato
effect is. The Footswitch must be plugged in and
Vibrato switched on for this control to work.
F. SPEED – Controls the rate of the Vibrato effect.
The Footswitch must be plugged in and Vibrato
switched on for this control to work.
G. REVERB – Controls the level of reverberation.
Reverb can be switched on-off, hands-free, from
the footswitch.
H. MIDDLE – Use to adjust mid-frequency re-
sponse.
I. BASS – Use to adjust low-frequency response.
J. TREBLE – Use to adjust high-frequency re-
sponse.
K. VOLUME – Adjusts the overall loudness of the
amplifier.
L. INPUTS – Generally, plug your guitar into the
NORMAL input. The BRIGHT input provides a tre-
ble boost and can be used as an input for a sec-
ond guitar.
• Rear Panel •
M. FOOTSWITCH – Plug the included footswitch
in here to enable remote switching of the Vibrato
and Reverb effects.
N. POWER CORD – Plug the amplifier into a
grounded A/C outlet in accordance with the volt-
age and frequency ratings specified on your am-
plifier.
Your new Gretsch Executive G6163 is the perfect
match for your Gretsch guitar—from delicate finger
picking to pounding Rock ‘N’ Roll! No master volumes
or channel switching, just plug in, find your sweet
spot, and let it rip! Features include:
• 20 watts output into one 15" speaker
• Reverb and Tremolo
• All tube circuitry—two 6V6 output tubes
• Point-to-point wiring
• Finger-jointed pine cabinet
• Two-tone heavy-duty space-age vinyl covering
• Made in the U.S.A.
—Thank you for choosing Gretsch and
That Great Gretsch Sound!™
The Gretsch® G6163 Executive — Guitar Amplifier
Panel Features
A PRODUCT OF:
THE GRETSCH CO.
SAVANNAH, GA USA
Gretsch® is a trademark of The Gretsch Co.
Other trademarks are property of their respective owners.
© 2005 The Gretsch Co. All rights reserved.
P/N 0069706000 REV A
Table of contents
