GRIDIRON BP-03 User manual

BP-03 Backpack Blower Rack
Thank you for purchasing this GRIDIRON product
Assembly and Installation
1The fasteners are assembled at the factory but can loosen during shipping.
Assemble any loose bolts and T-nuts only as shown (NOTE- Incorrect assembly will
result in damage)
2The GRIDIRON Backpack Blower Rack can be mounted to GRIDIRON Posts or to
other suitable framework (some scenarios may require locally acquired hardware)
3Mount the blower shelf at the desired height and location.
4Install the adjustable front panel on the shelf with the 4.75” T-nut, placing the T-
nut on the bottom of the shelf for added security. Leave bolts loose for final
adjustment.
5Install the adjustable side panel on the opposite side of your blower tube with the 4.75”
T-nut. Leave bolts loose for final adjustment.
6Install the locking bar assembly at the desired height to secure your blower. There are
three sets of mounting holes in the back bar to allow a shift to the left or right. There
are also slots on the end brackets to allow adjustment in or out to find the best fit for
your blower.
7Open the lock bar and place your blower on the shelf, adjust the front and side panel to
fit your blower, remove your blower and tighten all bolts.
8Mount the blower loop in a suitable location to allow secure storage and easy mounting
and dismounting of the blower tube. The loop can be placed above on the same
Gridiron post, to the side on another Gridiron post, on the trailer rail or wall, or any
other suitable location. (Obtain hardware locally for some mounting scenarios)
GRIDIRON post
(not included with BP-03 kit )
slot for in/out adjustment
(same on opposite end )
3 sets of mounting holes for
side to side adjustment

Operation
1 Lift the tab on the latch lever to allow the lock bar to be lifted to the
open position.
2 Place the blower tube into the loop and set the blower on the shelf.
Lower the lock bar into the latch until it is secure behind the latch
lever.
3 To lock, place a padlock on the back side of the latch lever to prevent it from opening.
(Padlock is not included with BP-03 kit )
The GRIDIRON Lifetime Guarantee
We want you to be a satisfied GRIDIRON customer forever, so we
stand behind our GRIDIRON products with a lifetime guarantee.
Performance Guarantee
If at any time, you are not completely satisfied with the performance of
your GRIDIRON product, we will correct or replace it.
Some Exceptions
The springs, shock cord elements, cutting edges, vinyl and plastic
protectors, and finish provided with your GRIDIRON products are
subject to normal wear and tear and are not covered by this guarantee.
GRIDIRON CTS
844-240-8695
www.gridironcts.com
[e-mail]
©2018 GRIDIRON CTS
All rights reserved
BP-03 REV 0 9/25/2019
insert padlock in this hole
(padlock not included )
Parts
Part # Description Qty
102055 bolt 3/8 x 1-1/4 2
102122 Spring (not shown) 1
102146 Double T-Nut - short 4
102426
Blower Loop Assembly
1
103074 bolt 5/16 x 5/8 12
103086 Double T-Nut - long 2
103098 Adjustable Retainer 2
103099 Back Bar 1
103100 Pivot Bracket 1
103101 Latch Base 1
103102 Latch 1
103103 Lock Bar 1
103105 Support shelf 1
0 Security Cone Nut 2