WATER
WATER
ON
Plug your machine in and
switch it ON using the On/
Off switch.
Open the Water Tank Cover
and fill the Water Tank with
fresh water to the Max. Line
indicator.
Along with the button lights,
the Indicator Light will
blink.
Check there is no capsule in
the Capsule Compartment.
Close the Lever.
Place a cup or mug (at
least 250mL) under the
Dispensing Spout.
Note: If the RED Indicator
Light continues to blink and
no water has been extracted
repeat Step 6.
Press the Hot Water button.
Water will cycle through
the system (approx. 30
sec.). When done, the RED
Indicator Light will switch
off.
When all the button lights
remain steadily lit, rinse
by pressing the Hot Water
button. Press again to
repeat the Rinse Cycle.
After Step 6 has been
successfully completed, all
the buttons will continue to
blink while your machine
warms up (approx. 1 min.).
Open the Water Tank Cover
and fill the Water Tank with
fresh water to the Max. Line
indicator. Your machine is
now ready to use.
Once you have completed
the Rinse Cycle, remove the
Drip Tray and Used Capsule
Drawer, empty any residual
water, rise with fresh water
and replace onto your
machine.
Insert the capsule, pressing
it gently into place.
Raise the Lever to open the
Capsule Compartment.
Hot Water Button -
120mL (Lit in BLUE).
Single Espresso Button
- 30mL (Lit in WHITE). Double Espresso Button -
60mL (Lit in WHITE).
Indicator Light
2.
4.
1.
3.
5.
i.6.
8.7.
10.9.
12.11.
