Grundig GBR-CM02 User manual

GBR-CM02.20.1.02.08.2011
Owner´s Manual
EN
© ASP AG
IP Cameras & Domes
GBR-CM02 Corner Mount Adapter

Content:
1. Introduction 1
2. Package Contents & Needed Items 1
3. Installation 2
1. Introduction
The Dome Cameras GCI-H0522V and GCI-K0322V can be mounted in an upper corner
with this Corner Mount Adapter.
The items and tools needed for installation are listed below.
2. Package Contents & Needed Items
These parts are included:
Tools Needed:
- Tool for drilling
- Phillips Screw Driver
- Security Torx (included in the package of the camera)
1
English

3. Installation
Step 1:
Match the Corner Mount Adapter to the
ceiling corner. Please note that the Dome
Camera’s Housing installing holes are in
position as shown in the figure on the left.
Step 2:
Drill six holes on the walls and the ceiling to
install six M4 plastic anchors.
Step 3:
Fix the Corner Mount on the Ceiling by
fastening the six M4 Screws in the Plastic
Anchors.
Step 4:
Place the Dome Camera’s Housing in the
Corner Mount Adapter. Please note that the
Dome Camera's Housing needs to be in the
same position as in the figure.
2English

Step 5:
Thread the RJ-45 cable (and a power cable
if needed) through the Dome Camera’s
Housing.
Step 6:
Tighten the four M4 Screws to install the
Dome Camera’s Housing in the Corner
Mount.
Step 7:
Place the Camera Module into the Dome
Camera’s Housing until there is a “click”
sound.
Step 8:
Tighten the screw on the Camera Module to
fix the Camera Module on the Dome
Camera’s Housing.
3
English

Step 9:
Connect the RJ-45 cable (and the power
cable if applicable) to the Camera Module,
and then adjust the Dome Camera lens to a
desired angle. Please note that the zoom
level and focal length might be different with
the Dome Cover on, in this case, adjusting
zoom level and focal length through the
Dome Cover is recommended. To do this,
please position the optical cover (cupola) of
the Dome Cover in front of the lens.
Step 10:
Put the Plastic Inner Cover back on the
Camera Module.
Step 11:
Screw on the two Torx screws on the side
of the Dome Cover tightly to fasten the
Dome Cover. The camera installation is now
complete.
4English

Specifications GBR-CM02
Suitable for GCI-H0522V; GCI-K0322V
Body material Steel
Colour White
0.5 kgWeight
222 × 204 × 117 mmDimensions (wxhxd)
5English