GUBI SATELLITE User manual

ASSEMBLY INSTRUCTIONS
for
SATELLITE FLOOR LAMP
For enquiries contact GUBI A/S - CVR: 17940384
Orientkaj 18-20. 2150 Nordhavn. Copenhagen, Denmark
T [phone] – [e-mail]
GUBI.COM
TECHNICAL INFORMATION
Light sources: E27, 810 Lumen (6-10W LED).
Turn power off when changing light bulb. Isolation class III.
The lamp is approved for oudoor use and in damp/wet rooms (IP65)
CARE INSTRUCTIONS
TROUBLESHOOTING
Daily cleaning can be done by wiping the frame with a clean dry cloth.
Should the surface need more attention this can be cleaned with water
and a light detergent or soap applied with a damp cloth. Wipe after with
a clean dry cloth. Avoid any abrasive materials.
If lamp does not light, turn off the power. Check the bulb for a broken
filament. Replace bulb if necessary, then turn it on. If the lamp still
does not light, please contact customer service at the local dealer. If
the external flexible cable or cord of this lamp is damaged, it must be
replaced by a qualified electrician in order to avoid a hazard.
186-20-030-01 Assembly Instructions Satellite Floor Lamp Outdoor EU

ASSEMBLY INSTRUCTIONS
CONTENTS
x1 x1 x1 x1x6 x1 x1 x1
1.
Install the stem and lampshade by placing it into the base (1a).
Make sure to tight the stem to base with the fingerscrew (1b).
2.
Unscrew 3 screws on stem connection (2a) tilt the shade
and unscrew the 3 screws on bottom plate (2b) to access
the socket.
(2a)
(2b)
(1b)
(1a)

4.
Assemble the top part by placing the hat (4a) on top of
the shade and attach with the screw (4b). Make sure it’s
properly tightened.
Re-assemble the lamp by following step 2 in reverse.
3.
Insert lightbulb (3a), silicone stopper (3b) and transparent
plastic cover (3c). Make sure that all 3 parts are installed
properly.
(3a)
(3b)
(3c)
(3b)
(3c)
Plug in the lamp and turn it on by using the
button placed on the stem.

PIN
1.
Install pin in the desired substrate (1a) When the bottom
disc touches the surface, pin is securely installed.
Place the stem into the pin (1b).
Make sure to tight the stem to pin with the fingerscrew
(1c).
x1
(1c)
(1b)
(1a)