Gusto FM-GT1800 User manual
FM-GT1800
www.techni-lux.com
&IGURE'4&UNCTIONS0AGE
Figure 1 FM-GT1800 Functions
Note Other Important Detail:
Plugging FM-GT1800 in, the red LED under tank bottom will glow
indicating power on & warming up. Check if with correct voltage in
case it doesn’t glow. A lit blue LED under tank bottom appears as
warm-up arrives at fogging point, indicating a finished heating
time. Besides, FM-GT1800 devise the low fluid sensor. LED
under tank bottom will automatically flash to warn low fluid supply,
no matter under warming-up (a lit red LED) or heating has
finished (a lit blue LED), provided fluid reduces to low level. The
pump stops simultaneously. Keep an eye on to ensure enough
fog fluid when running.
Should there be any low fog emitted, running noisily or hindered
fogging, pull out the plug immediately. Check if string enough fog
fluid, or if outside fuse, controller connection and power supply
improper, if not, plug-in again, still persists abnormal running,
check if with an unhindered pipe, with flowing fluid. If causation is
unclear, stop running to avoid any damage, shut down to cool it,
and bring unit to your local agent or appointed service place for
inspection prohibit any dismantlement by yourself.
MASTER/SLAVE Control Operation
Please use DC-3C for master/slave operation. Please put the
GT-1800 on a dry and flat surface, and then set the master fog
machine in accordance manual instructions. To connect another
fog machine, plug one end of a signal cable into the output socket
(E of figure 1) on the back of the master fogger and plug the other
end of the signal cable to the input socket on the back of a
second GT-1800. Follow this procedure to link more fog
machines.
