HABCO® TECHNICAL DOCUMENT - C096832 • 10126169
© HABCO Manufacturing Inc. “HABCO®, Cassette®, Cold Space Merchandiser®” are registered trademarks of HABCO Manufacturing Inc. Domestic and International Patents. Page 4
and engineered to the highest standards using only quality components
-
-
Advise your carrier, or HABCO (if shipped via our transport) of any
WARNING: RISK OF SUFFOCATION! KEEP PLASTIC PACKAGING MATERIAL
AWAY FROM CHILDREN AND ANIMALS, AND DISPOSE SAFE AND SECURE.
WARNING: RISK OF PERSONAL INJURY! EMPLOY BEST HEALTH AND SAFETY
LIFTING PRACTICES WHEN REMOVING SHIPPING PLATFORM(S); LEVELING
CABINET; REVERSING DOORS; AND MOVING APPLIANCE. IF IN DOUBT, ASK
FOR HELP.
HABCO® Foodservice and Commercial appliances are shipped
Insets on each side of skid are provided to allow easy access
for 1-3/8” wrench or socket to remove the levelers and skid
FIG. A1
HABCO® Commercial Refrigerators may be equipped with an
-
Install non-braking casters at rear of the refrigerator by
Install braking casters at front of the refrigerator by threading
-
otherwise door(s) may not close and condensate may not drain
WARNING: RISK OF FIRE, AND ELECTROCUTION!
DO NOT ALTER, IMPACT OR PLACE PRESSURE ON POWER CORD. AL-
LOW ADEQUATE SPACE FOR POWER CORD TO FLOAT FREELY BETWEEN
CABINET AND WALL AND DO NOT STRAIN AND/OR STRETCH POWER
CORD TO REACH ELECTRICAL RECEPTACLE.
DO NOT INSTALL OUTDOORS AND/OR IN DAMP CONDITIONS.
DO NOT INSTALL APPLIANCE WHERE STORAGE, HANDLING AND/OR DIS-
PENSING FLAMMABLE AND/OR EXPLOSIVE MATERIALS OCCUR.
NOTICE: RISK OF APPLIANCE DAMAGE!
DO NOT OBSTRUCT AIR-RETURN GRILLS LOCATED INSIDE CABINET NEAR
THE LOWER LEFT AND RIGHT OF THE REAR AIR DISTRIBUTION PANEL. DO
NOT BLOCK EXTERIOR, LOWER FRONT GRILL. FAILURE TO COMPLY MAY
RESULT IN RESTRICTED AIR CIRCULATION, SUBSTANTIALLY REDUCED COOL-
ING PERFORMANCE AND DAMAGE TO REFRIGERATION COMPONENTS
AND VOID WARRANTY.
DO NOT LOCATE APPLIANCE IN CLOSE PROXIMITY TO HIGH HEAT SUCH AS
FRYERS, RANGES, AND/OR HEATING DUCTS.
DO NOT INSTALL DIRECTLY BENEATH UNDIFFUSED AIR CONDITION-
ING VENTS.
DO NOT INSTALL OUTDOORS, IN DIRECT SUN, DAMP, EXTREME HEAT
AND/OR COLD CONDITIONS.
WARNING: RISK OF DEATH, FIRE, EXPLOSION, ELECTRICAL SHOCK AND/OR
OTHER PERSONAL INJURY!
PLUG INTO A DEDICATED, 3 PRONG GROUNDED ELECTRICAL RECEP-
TACLE AND DO NOT USE EXTENSION CORDS, POWER BARS, AND/OR
ADAPTERS TO POWER THIS APPLIANCE. IF IN DOUBT, EMPLOY A CERTI-
FIED ELECTRICIAN TO CONFIRM YOUR POWER SUPPLY MEETS CRITERIA.
DO NOT ALTER, IMPACT OR PLACE PRESSURE ON POWER CORD. AL-
LOW ADEQUATE SPACE FOR POWER CORD TO FLOAT FREELY BETWEEN
CABINET AND WALL AND DO NOT STRAIN AND/OR STRETCH POWER
CORD TO REACH ELECTRICAL RECEPTACLE.
INSPECT POWER CORD FOR ANY DAMAGE PRIOR TO POWERING AND
WHENEVER HABCO® CASSETTE® IS EXCHANGED OR APPLIANCE IS MOVED.
DO NOT PLUG THIS APPLIANCE INTO WALL RECEPTACLE IF POWER
CORD IS DAMAGED.
DO NOT ACCESS MECHANICALLY FASTENED AREAS WITHOUT PERMIS-
SION OF OWNER AND READING AND UNDERSTANDING PRODUCT
MANUAL.
