Haier DW-40L626 User manual

D
eep
F
reezer
User's manual
DW-40L626
Please read this manual
carefully before using.
Retain it for future reference.

2
3
4
5
6
6
6
8
9
10
11
12
13
13
Diagram of Parts
Safety Precautions
2. Operation introduction
1
40
40
700
40
1
3

12
Technical data in this manual may vary from that of the product
you have just purchased due to technical improvement.
Microprocessor
40 40
auto-
Intelligent
service
1

Handle
Compressor
Cabinet
Control
Panel
Foaming
Door
from
2
Gurgal
Gurgal
11

1
0
3

4
9

ULT freezer should be in charge of special person and check and record the
operation condition in everyday. If it meet power cut or any other failures and the
freezer doesn't work, the temperature inside cabinet will increase. And if there will
be without power for a long time, please get out the storage and load them into
other low temperature container for avoiding samples damage.
Please confirm again the temperature inside freezer is what you need before you
load the goods into freezer, otherwise, it will be make damage to the goods for
improper temperature.
8
Leave the appliance standing in its final position for at least 24 hours before switching it on. Before
power on, please do switch on the charge battery switch of the electric cabinet at the back of the
machine can be seen at the back of the machine, about the charge battery switch fixed on the
electric cabinet, and the charge battery switch is at the right up of the outlet of the electric cabinet
power cord.
1.
User's
manual
5

Haier Deep Freezer
-40
6
When the operator need to stop the machines, first cut down the power supply
(but the display board work all the same, this function is supplied by the
charge battery), and then close the switch of charging battery which located
at electric control box behind the cabinet.
Silence
At the state of unlock, press this key to set temperature
First press “up”, digital temperature begin to flash, and press” up” or “down”
and let the value to “06”, then press the “SET” key for about 3 seconds. “lock”
light die, that means it has enter unlock state. Press “SET” key again, check
and set cabinet temperature, high temperature alarm, low temperature
alarm step by step. Press “up” and “down” unconsciously, the temperature
will be set per 1 , and if press keys continuously, the temperature value will
be increased or decreased very quickly.
When copressor is in operation, compressor is on display.
7