Haier Thermocool BD-100E User manual

IMPORTANT
Please read this Owner’s Manual carefully before using your freezer. Keep in a safe place for future reference.
Thank you for choosing
BD-100E BD-142E BD-198
CHEST FREEZER
USER MANUAL
BD-100E BD-142E BD-198
12
M
O
N
T
H
S
W
A
R
R
A
N
T
Y
12
M
O
N
T
H
S
W
A
R
R
A
N
T
Y

Table of Contents Outline Drawing Page 1 Important Safeguards Page 2-3 Electric Control panel Page 4 Freezer Installation Page 5 Energy Saving Tips Page 6 Operating the Freezer Page 6-7 Care and Cleaning Page 8 Defrosting Page 9 Useful Hints Page 10 Troubleshooting Page 10-11 Guide to Home Freezing Page 12 Accessories List Page 13 Technical Data and Wiring Diagram Page 14 Warranty Page 15

1
Included in the
Following Models
BD-100E/142E/198
(1) Hinge Yes (2) Sealing gasket Yes (3) Light Yes (4) Food Basket Yes (5) Drainage Plug Yes (6) Control Panel Yes (7) Ventilation grill for compressor Yes (8) Lock Yes

DANGER
AVOID THE RISK OF CHILD ENTRAPMENT. BEFORE THROWING AWAY AN OLD REFRIGERATOR OR FREEZER, TAKE OFF THE DOORS/LIDS AND REMOVE THE SHELVES SO THAT CHILDREN CANNOT GET TRAPPED INSIDE.
Important Safeguards
Read all instructions before using this appliance.
When using this appliance, always exercise basic safety precautions, including the following: 1) Use this appliance only for its intended purpose as described in this guide. 2) Remove all packaging before commencing freezer operation. 3) This freezer must be installed properly in accordance with the installation
instructions before it is plugged in and used. See grounding instructions in the installation section.
4) This freezer is designed for freestanding installation only and it should not be
recessed or built in.
5) At least 7.5cm air space on top, sides and back of the freezer should be
given. This allows air to circulate freely and helps to prevent condensation on the cabinet.
6) It is recommended that the freezer is cleaned before use as per the ‘Care
and Cleaning Instructions’ in this manual.
7) Never unplug your freezer by pulling on the power cord. Always grip the plug
firmly and pull it straight from the outlet.
8) Replace or repair immediately all electric service cords which may have
become frayed or otherwise damaged. Do not use cord that shows cracks or abrasion damage along its length or at either the plug or connector end.
9) If your old freezer is still around the house but not in use, be sure to remove
the doors to reduce the possibility of danger to children.
10)
Unplug your freezer before cleaning or before making any repairs. NOTE:
We strongly recommend that any servicing or repairs be undertaken by a suitably qualified technician.
11)Do not refreeze any foods which have been thawed.
2 15
Limited
45/47, Town Planning Way, llupeju Industrial Estate,
P.M.B 21132,Ikeja,Lagos, Nigeria.
Tel: [phone],
Fax: [phone],
E-mail: [email protected]
WWW.htcool.com
HPZ

12)Do not use any electrical devices or sharp instruments to defrost the freezer. 13)Food should only be placed inside the freezer 8 hours after the freezer has
been turned on to avoid wasting power and over working the compressor.
14)Ensure that hot food is allowed to cool completely before freezing. 15)Do not overfill the freezer. Where possible, large blocks of meat should be
cut and wrapped in smaller pieces. Space should be left between packages of food to enable air to circulate at all times.
16)Never place combustible, explosive or volatile liquid, gas or other materials in
the freezer.
17)Do not install the freezer in the same vicinity of any combustible, explosive or
volatile liquids/gases.
18)Do not leave beverages such as beer, soft drinks or other liquids packaged
in glass containers in the freezer. Such liquids will expand upon freezing and can cause the glass to break.
19)Do not put water directly in to the tank of the freezer.
3
65 65
Lid
67
14

4
BD-100E/142E/198
13

Freezer Installation 1) The freezer is designed for free-standing installation only. 2) The freezer should not be recessed or built in. 3) Install the freezer on a base strong enough to support it when fully loaded.
Ensure the freezer is on a stable surface to minimise noise and vibration.
4)When moving the freezer, never tilt at an angle more than 45
o
as this could
damage the compressor and freezer system. If the freezer is tilted over 45
o
, or
has been stored on its side, allow the freezer to stand upright for at least 24 hours prior to plugging it back in. This will allow the refrigerant to settle.
5) Install the freezer in a well-ventilated area away from any heat source or direct
sunlight. Air must be allowed to circulate freely around the freezer. Allow at least 3inches (7.5cm) of clearance space for the top, back and sides.
6) Install the freezer in a dry place to prevent rust from forming on the compartment
body and to avoid the risk of damaging the electric insulation.
Electrical Connection and Precautions 1) IMPORTANT – For personal safety, this appliance must be properly
earthed.
2) The voltage range for this appliance is 187v – 242v. In the event that your
regional power supplier cannot meet this requirement, please use a safe and reliable automatic voltage regulator with a minimum output of 500W to avoid damaging the compressor.
3) A 13 Amp, 3 pin plug and 5 Amp fuse only must be used for this freezer to avoid
serious damage. The plug should always be wired in accordance with the following codes:
Green and Yellow EARTH (E) Blue or Black Neutral (N) Brown or Red LIVE (L)
It is safest to consult a qualified electrician at all times
4) In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electrical current. This appliance is
1) 2) 3) 1) 2) 3) 4) 5) 6) 4)
5
12

5)
6
11

7
10

8 9