999-224Be20190503
Before you begin, remove the contents from all packing materials and lay out all the items to
ensure the product is complete prior to assembly.
1. Place the base upright on its front
edge and insert the riser screw
through the hole from the bottom
side of the base.
2. While holding the base and riser,
screw with one hand then attach
the the riser using your other hand,
threading it onto the riser screw.
3. Use the supplied hex wrench to
tighten the riser screw.
4. Place the base at on its support
feet and secure the riser ring
approximately half way up the riser
using one of the three supplied
tension knobs.
5. Remove the cap from the riser.
6. Carefully slide the arm and cross-
block assembly down over the riser
until it rests on the riser ring.
NOTE: Be sure the attachment
point for the head assembly is
on top as pictured.
7. 7. Secure the arm and cross-block
assembly with the remaining
two tension knobs.
8. Replace the cap on top of the riser
that was removed in Step 5.
9. Insert the pin for the head
assembly into the attachment point
from the bottom.
10. Secure the head assembly by
threading the locking lever into the
attachment point until it is snug.
11. Using the supplied hex wrench,
tighten the adjustment screw on the
bottom of the head assembly to
secure it in a position that is approx-
imately parallel to the work surface.
12. Insert the adapter ring with the
larger opening facing up.
HOW TO USE
1. Insert your Hakko Hot Air SMD
Rework Station handpiece into
the adapter ring.
2. Secure the handpiece by tightening
the three socket head set screws with
the appropriate size hex wrench.
3. Place the handpiece with adapter ring
into the head assembly and secure
by tightening the small thumb screw
on the right-hand side of the head
assembly.
ASSEMBLY
