Hall Technologies ULTRA-V Series User manual

User’s Manual
ULTRA-V Series
4K UHD HDMI Splitter/Extender
over 1 CAT6 to 100m/328ft
Part Number Function
ULTRA-V-1S Single-port Sender with Local HDMI Output
ULTRA-V-4S Four-port Sender with Local HDMI Output
ULTRA-V-8S Eight-port Sender with Local HDMI Output
ULTRA-V-R Single-port Receiver
UMA1276 Rev E
Order toll-free in the U.S. 800-959-6439
FREE technical support: 714-641-6607 or [e-mail]
Hall Technologies, 1163 Warner Ave. Tustin, CA 92780
www.halltechav.com
CUSTOMER
SUPPORT
INFORMATION

ULTRA
-
V
-
S and ULTRA
-
V
-
R
2
© Copyright 20
20
Hall
Technologies
Table of Contents
1.0 Introduction ................................................................................. 3
Features ................................................................................................. 3
2.0 Package Contents ........................................................................ 4
3.0 Setup .............................................................................................. 4
Installation ............................................................................................. 4
DisplayPort Adapters ............................................................................ 5
4.0 Connector and Indicator Functions ......................................... 6
ULTRA-V-1S FRONT .......................................................................... 6
ULTRA-V-1S REAR ............................................................................ 6
ULTRA-V-4S / -8S FRONT ................................................................. 7
ULTRA-V-4S / -8S REAR.................................................................... 7
ULTRA-V-R FRONT ........................................................................... 8
ULTRA-V-R REAR .............................................................................. 8
5.0 Troubleshooting .......................................................................... 9
Contacting Hall Technologies ............................................................... 9
6.0 Specifications ............................................................................. 10
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference even if it causes undesired operation.
This equipment has been desinged to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy, and if it is not installed and used in accordance with the instruction
manual, it may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense.

4K UHD Extender Over CAT6
© Copyright 20
20
Hall
Technologies
3
1.0 Introduction
The ULTRA-V series are a family of extenders used to extend HDMI video
to one or more remote locations up to 100m (328ft) over a single CAT6
cable. The extenders support various resolutions including 1080p @
60Hz and 4K UHD @ 30Hz.
The Senders are available in three versions. ULTRA-V-1S has a single
remote output, ULTRA-V-4S has four, and ULTRA-V-8S has eight. All
Senders feature an HDMI input and a local HDMI “loop” output. This
allows for connection of a local display, or daisy chaining the HDMI to
another Sender to increase the number of remote displays.
The Receivers have a single remote input, and one HDMI output for
connection to a remote display.
Typical Connection Diagram
Features
 Supports high resolution HDMI video including FHD
(1920x1080), WQHD (2560x1440), and 4K UHD (3840x2160)
 Local HDMI outputs at all Senders to connect to a local display, or
to daisy-chain a second ULTRA-V Sender
 1,4, or 8 outputs to distribute video to multiple locations
 No video calibration required, no video quality reduction due to
cable length.
 ULTRA-V Receivers are compatible with ULTRA-4K Sender

ULTRA
-
V
-
S and ULTRA
-
V
-
R
4
© Copyright 20
20
Hall
Technologies
2.0 Package Contents
ULTRA-V-1S / -4S / -8S
(x 1) ULTRA-V-1S / -4S / -8S
(x 1) POWER SUPPLY (Hall P/N 511-IEC5V4AP5L, Mfg P/N 3A-186DB05)
(x 1) USER’S MANUAL CARD
ULTRA-V-R
(x 1) ULTRA-V-R
(x 1) POWER SUPPLY (Hall P/N 511-IEC5V4AP5L, Mfg P/N 3A-186DB05))
(x 1) USER’S MANUAL CARD
3.0 Setup
Installation
 Connect the HDMI Source to the ULTRA-V Sender port marked
“HDMI IN” using a quality HDMI cable
 Optionally, connect HDMI Display to the ULTRA-V Sender port
marked “HDMI OUT” or daisy-chain to a second ULTRA-V “HDMI
IN” port
 Using CAT6 cable(s), connect the ULTRA-4K-S “OUTPUT” port(s) to
the ULTRA-V-R “INPUT” port
 Connect ULTRA-V-R “HDMI OUTPUT” to a Display using a quality
HDMI cable
 Once all connections have been made, apply power to the ULTRA-V
Sender(s) and ULTRA-V-R Receiver(s)
NOTE The ULTRA-V-R Receiver’s RJ45 input may also be connected
to ULTRA-4K-S sender (or the RJ45 loop output on the
ULTRA-4K-R Receiver). When plugged to ULTRA-4K, the
Receiver will show the Video A by default. The ULTRA-V-R
Receiver can be set to display Video B by the user (please
contact Hall Technologies technical support for details).

4K UHD Extender Over CAT6
© Copyright 20
20
Hall
Technologies
5
DisplayPort Adapters
While HDMI is the most widely adopted video standard, there are a number of
computer and display manufacturers that rely on DisplayPort for higher
resolutions such as 2560 or 4K. Hall Technologies offers 4K compatible
adapters to convert between these two video standards.
To connect to a source (PC) with Displayport output, use GC-DP-HD.
Model GC-DP-HD: DisplayPort source to HDMI output
Virtually all monitors and TVs have HDMI (or DVI) inputs, but if your display
only has Display port input, the following adapter converts HDMI to DP.
Model GC-HD-DP: HDMI source to DisplayPort output
NOTE These adapters are unidirectional. For example, the
DisplayPort to HDMI adapter cannot convert an HDMI signal
to DisplayPort.

ULTRA
-
V
-
S and ULTRA
-
V
-
R
6
© Copyright 20
20
Hall
Technologies
4.0 Connector and Indicator Functions
ULTRA-V-1S FRONT
1 2 3 4 5
1) 5V DC: Power input. Connect supplied 5V power supply to power
Sender.
2) SERVICE: USB-Mini connection, used to restore factory defaults via PC
GUI.
3) PWR/VID/ACT: Status indicators
a. PWR: This LED indicates power is applied to the unit.
b. VID: This LED is lit when HDMI video input is present.
c. ACT: This LED blinks when HDMI processor is active (normal).
4) HDMI OUT: HDMI local Output.
5) HDMI IN: HDMI Input port.
ULTRA-V-1S REAR
1
1) OUTPUT: CAT6 Output port to ULTRA-V-R Receiver.

4K UHD Extender Over CAT6
© Copyright 20
20
Hall
Technologies
7
ULTRA-V-4S / -8S FRONT
1 2 3 4 5
1) 5V DC: Power input. Connect supplied 5V power supply to power
Sender.
2) SERVICE: USB-Mini connection, used to restore factory defaults via PC
GUI.
3) PWR/VID/ACT: Status indicators
a. PWR: This LED indicates power is applied to the unit.
b. VID: This LED is lit when HDMI video input is present.
c. ACT: This LED blinks when HDMI processor is active (normal).
4) HDMI OUT: HDMI local Output.
5) HDMI IN: HDMI Input port.
ULTRA-V-4S / -8S REAR
1
1) OUTPUTS: CAT6 Output ports to ULTRA-V-R Receivers. (Note: ULTRA-
V-4S has output ports 1 through 4)

ULTRA
-
V
-
S and ULTRA
-
V
-
R
8
© Copyright 20
20
Hall
Technologies
ULTRA-V-R FRONT
1 2 3 4
1) 5V DC: Power input. Connect supplied 5V power supply to power
Sender.
2) SERVICE: USB-Mini connection, used to restore factory defaults via PC
GUI.
3) PWR/VID/ACT: Status indicators
a. PWR: This LED indicates power is applied to the unit.
b. VID: This LED is lit when HDMI video is being output.
c. ACT: This LED blinks when HDMI processor is active (normal).
4) HDMI OUT: HDMI local Output.
ULTRA-V-R REAR
1
1) INPUT: CAT6 Input port from ULTRA-V-S Sender.

4K UHD Extender Over CAT6
© Copyright 20
20
Hall
Technologies
9
5.0 Troubleshooting
If you are experiencing problems getting the ULTRA-V extender to work
properly, please use the following troubleshooting suggestions.
 Ensure that all connections are secure. Check all status LEDs to ensure
proper operation.
 Try resetting the system by unplugging the power supply, waiting 5
seconds and plugging it back.
 Try restoring factory defaults using the PC GUI.
Contacting Hall Technologies
If you determine that your ULTRA-V extender is malfunctioning, do not attempt
to repair the unit.
Instead, contact Hall Technologies Technical Support at 714-641-6607. To
return the unit to Hall Technologies you must first get a Return Authorization
(RMA) number.
Package the unit carefully, if returning. We recommend that you use the original
container.
NOTE There are no user-serviceable parts inside. Do not attempt to
try to repair the unit yourself, as this will void your
warranty.

ULTRA
-
V
-
S and ULTRA
-
V
-
R
10
© Copyright 20
20
Hall
Technologies
6.0 Specifications
Video
Standards
DVI (single link)
HDMI 1.4 video specifications including 12 bit color depth, 3D video
HDCP 1.4
Connectors
ULTRA
-
V
-
1S
(1) HDMI Input
(1) HDMI Output
(1) RJ45 Output
(1) Mini-USB Service Port
(1) 2.0MM Locking DC Power Input
ULTRA-V-4S
(1) HDMI Input
(1) HDMI Output
(4) RJ45 Outputs
(1) Mini-USB Service Port
(1) 2.0MM Locking DC Power Input
ULTRA
-
V
-
8S
(1) HDMI Input
(1) HDMI Output
(8) RJ45 Outputs
(1) Mini-USB Service Port
(1) 2.0MM Locking DC Power Input
ULTRA-V-R
(1) HDMI Output
(1) RJ45 Input
(1) Mini-USB Service Port
(1) 2.0MM Locking DC Power Input
Refresh Rates
60 Hz for resolutions upto and including HD (1920x1080) and WUXGA
(1920x1200
30 Hz for resolutions above and including QHD (2560x1440)
Resolutions
DVI signal
VGA (640x480) thru
WUXGA (1920x1200)
HDTV signal 480p through 4K60 4:2:0 (Interlaced resolutions are not
supported)
General
Power S
upply
100 VAC to 240 VAC, 47
-
63 Hz, External;
5
VDC
Temp/humidity
Storage:
-
40 to +158 °F (
-
40 to +70 °C) / 10% to 90%, non
-
condensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, non-condensing
Power
5
VDC,
4
.0 A Power Supply
Cooling
Convection
Enclosure type
Metal (Steel)
Dimensions
Model Device Shipping
ULTRA-V-1S 5.50’’L x 4.40’’ W x 1.27’’ H 5.30” L x 8.70” W x 3.10” H
ULTRA-V-R 5.50’’L x 4.40’’ W x 1.27’’ H 5.30” L x 8.70” W x 3.10” H
ULTRA-V-4S 6.90’’ L x 7.12’’ W x 1.45’’ H 7.55’’ L x 10.15’’ W x 2.65’’ H
ULTRA-V-8S 6.90’’ L x 7.12’’ W x 1.45’’ H 7.55’’ L x 10.15’’ W x 2.65’’ H
Product
weight
Model Device Shipping
ULTRA-V-1S
1.01 lbs
( 0.46 kg)
2.8 lbs (1.3 kg)
ULTRA-V-R
1 lbs
( 0.45 kg)
2.5 lbs (1.1 kg)
ULTRA-V-4S
1.83 lbs
( 0.83 kg)
3.5 lbs (1.6 kg)
ULTRA-V-8S
1.92 lbs
( 0.87 kg)
4.0 lbs (1.8 kg)
Safety
CE
EMI/EMC
CE, FCC
Class A
MTBF
9
0,000 hours (estimate)
Warranty
3 years parts and labor
Specifications are subject to change without notice

© Copyright 2020. Hall Technologies
All rights reserved.
1163 Warner Ave, Tustin, CA 92780
Ph: [phone]