Hamilton AMERICAN CLASSIC PSR User manual

HAMILTON PSR | INSTRUCTION MANUAL

Your Hamilton PSR watch features a special push button which lights up time on demand.
Standard Illuminated
1 2 0 0

Standard time display
The Hamilton PSR watch displays the time using
the AM/PM time system.
Time illumination
Briey press the push-button so that the time
is illuminated.
If no other action is taken, the display will
return to standard mode after 4 seconds.
While the time is illuminated, press the push-but-
ton again to display the seconds.
Pressing the push-button again will take you
back immediately to the standard display.
If no other action is taken, the display will return
to standard mode after 10 seconds.

1. Activating setting mode
Press and hold the push-button for 3 seconds to
enter time-setting mode.
Follow the numbered steps 1 to 8.
The time to be set will ash, and «A» or «P» will
be displayed on the right. This tells you that the
time is in the morning «AM», or afternoon «PM».
If no other action is taken, the display will return
to standard mode after 5 seconds.
Note: Once the display returns to standard
mode, the last change made will be saved. This
is valid for each setting step.
2. Hour setting (AM/PM)
Every press on the push-button increases the
value by one unit.
Example:
Press four times to change from 10 o’clock (AM)
to 2 o’clock (PM).
Standard display
Setting mode: display will ash

6. Setting the minute units
Every press on the push-button increases the
value by one unit.
Example: Press three times to change from 2:44
to 2:47.
4. Setting the minute tens digit
Every press on the push-button increases the
value by one unit.
Example: Press two times to change from 24 to
44 minutes.
5. Switching to minute units digit setting
Press and hold the push-button for 2 seconds
to switch to minute units digit setting.
If no other action is taken, the display will return
to standard mode after 10 seconds.
3. Switching to minute tens digit setting
After setting the hour, press and hold the
push-button for 2 seconds to switch to minute
tens digit setting.
If no other action is taken, the display will return
to standard mode after 10 seconds.

8. Restarting the seconds
A short press on the push-button will restart the
seconds from zero, and the display will immedi-
ately return to standard mode.
To ensure the setting is accurate to the second,
moved the time forward to one minute ahead
of the time used as a reference.
Example: Set your watch to 2 : 4 7, and then wait
for the reference time (2 : 4 6) to change to 2 : 4 7
before pressing the push-button.
7. Switching to seconds setting
After setting the minute, press and hold the
push-button for 2 seconds to switch to seconds
setting.
Note: In time-setting mode, the seconds are
automatically reset.
If no other action is taken, the display will return
to standard mode after 60 seconds, and the
seconds will restart automatically.

Battery end-of-life indicator
Briey press the push-button while the display
is ashing; “bat” will be displayed to indicate
that your battery needs to be replaced shortly.
Press the push-button again or wait for 4 seconds
to go back to the standard ashing display.
Note: Although the display is ashing, your watch
will continue to run correctly, and settings will
remain possible.
Battery end-of-life
When the battery needs replacing, the standard
display will start ashing.
For battery changes, please
go to a HAMILTON approved
maintenance centre, or a
HAMILTON point of sale.