Hamilton Khaki Automatic Frogman User manual

K h a K i a u t o m at i c
F r o g m a n
i n s t r u c t i o n m a n u a l

© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN 
English 2
Français 4
Deutsch 6
Italiano 8
Español 10
Português 12
Nederlands 14
Svenska 16
Türkçe 18
Ελληνικά 20
Русский 22
Česky 24
26
28
30
32
35

2© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN
Hamilton is delighted that you have chosen a timepiece from its collection. You have acquired a small
technological marvel that will serve you faithfully for many years. The most advanced technologies were
used throughout its manufacture and it underwent stringent controls before it was released for sale.
Recommendations
Like all micro-mechanical precision instruments, your Hamilton watch should be checked at least once every two
years. Entrust your watch only to an authorized Hamilton agent. To keep your watch water-resistant, make sure
that its sealing features are tested at every check-up.
The water-resistance of your watch is 20 ATM = 200 meters = 660 feet.
Five basic rules for maintaining the water-resistance of your watch
1. Have your watch checked regularly.
2. Do not move the crown when you are in water.
3. Rinse o your watch after immersion in water.
4. Dry your watch whenever it gets wet.
5. Have your watch checked for water-resistance by an authorized
Hamilton agent each time the case is opened.
Your watch is tted with an automatic movement. The mechanism of the watch includes an oscillating rotor that
winds the mainspring via the motion of your wrist. The running reserve is approximately 42 hours. If necessary,
the watch may be rewound manually. The beauty of the inner working of the watch movement can be admired
through the transparent case back.

© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN 
Features
A) Crown protector
B) Start-Stop button
C) Reset-to-zero button
D) Crown protector
E) Crown for adjustment of time and date
1) 60-second counter
2) 30-minute counter
3) 12-hour counter
4) Date
Adjusting the time
1. Unscrew the crown protector (D).
2. Pull out the crown (E) fully to position (p2).
3. Adjust the time by turning the
crown in the desired direction.
4. Push the crown fully back in and screw
down the crown protector (D).
Adjusting the date
1. Unscrew the crown protector (D).
2. Pull out the crown (E) to the
intermediate position (p1).
3. Turn the crown clockwise until the desired date
is displayed. Avoid performing this operation
between 8 p.m. and 2 a.m. (2000 and 0200).
4. Push the crown fully back in and screw
down the crown protector (D).
Measuring a single time with the
Start-Stop function
1. Unscrew the crown protector (A) to
access the chronograph buttons.
2. Press button (B): the chronograph starts.
3. Press button (B): the chronograph stops.
4. Press button (C): reset to zero.
5. After use, make sure to screw down
the crown protector (A).
NB: before starting a time measurement, the hands
should be reset to zero. If necessary, push button (C).
Add function
For measuring successive times
(each time is added to the previous total).
1. Unscrew the crown protector (A) to
access the chronograph buttons.
2. Press button (B): the chronograph starts.
3. Press button (B) again: the chronograph stops.
4. Repeat steps 2 and 3 for as many time
measurements as desired. At the end of
the nal step, the chronograph displays the
total time, i.e. the cumulated time of all the
measurements. Press button (C) to reset to zero.
5. After use, make sure to screw down
the crown protector (A).

26 © HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN

© HAMILTON 2006 / KHAKI AUTOMATIC FROGMAN 2

www.hamiltonwatch.com
H860.000.025