HAMPBACK TD-PK-1 Series User manual

3. Attach the Cymbals
Knob nut
Felt washer
Check bracket
Tighten screw Insert cymbal and align it with
indentation. Adjust knob nut to fix it
Sensing range of cymbal
Place directly
below the Hi-Hat
4-A. Attach the Pedals
TD-PK/MK-1SeriesSetup GuideV2.0
A
400mm
400mm
550mm
350mm
Assemble the Stand and Pad1.
According to above figure, to assemble the stand and pad in turn.
Tom 1 Tom 2
Tom 3
Snare
400mm
400mm 550mm
700mm 700mm
785mm 785mm
350mm
500mm
≥10mm
Assemble the Cymbal Mounts2.
Tom 1 Tom 2
Tom 3
Snare
≥10mm
Cymbal Mounts ×3/4
Attach the cymbal mount holder
to the top of the 785mm tube
Insert the cymbal mount as
shown and tighten the screws
B
785mm
785mm
Crash 1
Ride
Hi-Hat
Crash 2Crash 1
Hi-Hat
Ride
Hi-Hat

12
3
TMH-0801
TSS-0801
7. Getting Ready to Play
Place directly
below the Hi-Hat
Bow shotEdge sensor
Pads: (Snare, Tom1/2/3)
Head shot Rim shot
Cymbals: (Hi-Hat, Crash, Ride)
Head shot
Adjust the beater
Adjust the center of
gravity of beater Adjust the gradient of beater
Adjust the tightness
of spring
Hi-Hat Control Pedal
Open Hi-Hat Half-open Hi-Hat Closed Hi-Hat
1
2
3
Attach the Kick Pedal4-B.
On the blanket
On the floorInstall the kick pedal securely Position beater at the
center of kick drum
Install the beater into the holder securely by fixing the screw
Hi-Hat
Attach the Sound Module
Insert sound module, adjust wing
knob to fix it and connect adudio
cable
5.
Hi-Hat
Crash 1
Kick
Sound
Module
Hi-Hat Pedal
Power Connection & Wiring6.
Crash 2
AC Adapter DB25 Audio Cable
TMH-0801 TSS-0801
To connect the jacks as shown in the figure, and using cable clip to organize the cables
Tom 1 Tom 2
Ride
Snare
Tom 3