Hand&Eye Duo Instruction Manual

[e-mail]
handandeyestudio.co.uk
©2019
Lighting for all the senses.
Duo
Instructions & Safety
Information EU/USA
Design by
Thomas Housden
Material & nish
Terracotta / Earthenware, opal glass
Dimensions & weight
Small Ø100mm, H.200mm, 1.2kg
Small Ø3.9 Inch, H.7.8inch, 2.64lb
Large Ø150mm, H.300mm, 1.8kg
Large Ø5.9Inch, H.11.8inch, 3.9lb
Lamp type & wattage
• E27 lamp max 6W LED bulb (bulb not included)
• USA- E26 lamp max 6W LED bulb (bulb not included)
• Inline switch and plug (UK/EU/US)
IP rating
IP20
Wiring certication
CE, EN60598
Options
Duo- raw terracotta & gloss opal glass
Duo Colour- dark blue gloss glazed earthenware &
gloss opal glass
Dimensions- Side view
150150
150
100100
100
150150
150
100100
100

[e-mail]
handandeyestudio.co.uk
©2019
Lighting for all the senses.
• The glass shade can fall out and brake if the lamp falls
over. It is recommended to secure the lamp to a
surface to prevent this.
• Always place the lamp on a at and stable surface
• Ensure a light bulb of max 6W is used. We recommend
an LED light bulb.
• If the light bulb breaks ensure lamp is unplugged
before handling the light bulb.
• Do not insert ngers in to lamp holder if there is no
light bulb and lamp is plugged in. Always ensure lamp
is unplugged before making any changes.
• Always turn o the power before changing a light bulb
Duo
Safety Information EU/USA

[e-mail]
handandeyestudio.co.uk
©2019
Lighting for all the senses.
Duo
Assembly Instructions EU/USA
1/1
1. Glass shade
2. Max 6W bulb (not supplied)
3. Lamp holder E27 (E26 USA)
4. Metal weight
5. Two core electric ex with woven fabric sheathing, switch and plug.
6. Ceramic base
7. Metal washer & screw
Diagram 1
Lamp components
Steps
A Assembly
The lamp holder (3) and weight (4) will already be
screwed into the bottom of the Duo light (6).
Step 1: Fit Lightbulb
Screw in your E27 (E26 USA) light bulb of Max 6W (2) into
the lamp holder (3).
Step 2: Add the glass shade
Carefully place the glass top (1) into the ceramic base.
BSecuring Duo to a surface
For additional stability, we recomend that you
secure the Duo lamp to a surface.
Step 1:
Decide where you want the lamp to be placed, mark and
drill a hole into the surface using a 5mm drill.
Step 2:
Now carefully remove the glass top (1) and place to the
side. Unscrew the lamp holder (3) and weight (4) from
the bottom of the Duo lamp (6).
Step 3:
Push the screw (8) through the hole you have drilled into
the surface and through the hole the base of the duo
lamp. Depending on the surface you wish to secure the
lamp to you may need a longer screw than that which we
supply (4mm screw diameter, M4).
Now screw the weight(4) and lamp holder (3) back to the
bottom of the Duo lamp and it will be secured.
2
3
5
6
1
4
7