E-9
ELECTRONIC VOLUME CONTROL
- THIS UNIT USES AN ELECTRONIC VOLUME CONTROL.
- TO INCREASE OR DECREASE THE LOUDNESS OF UNIT, (PUSH BUTTON TYPE) PRESS
THE VOLUME UP (VOL +) OR VOLUME DOWN (VOL -) CONTROLS.
- RELEASE THE KNOB WHEN VOLUME LEVEL IS AT DESIRED LOUDNESS.
OPERATION OF RADIO
- PRESS THE BUTTON ONCE TO SWITCH ON THE SYSTEM POWER.
- PRESS THE BUTTON TO SELECT THE DESIRED RADIO BAND.
- FOR MW (AM) STATIONS, ROTATE OR REPOSITION THE SET TO IMPROVE RADIO
RECEPTION.
- FOR FM STATIONS, EXTEND AND ADJUST THE TELESCOPIC ANTENNA TO OBTAIN
THE BEST RECEPTION.
- USE THE FM MONO/STEREO BUTTON TO SELECT THE DESIRED MODE. IN SOME
CASES, WHERE RECEPTION IS POOR, IT MAY BE ADVISABLE TO SELECT
“MONO” MODE, TO IMPROVE CLARITY OF THE RADIO SIGNAL.
POWER
TUNER
MUSIC EQUALIZER
- PRESS BUTTON REPEATEDLY TO CHOOSE THE DESIRED SOUND EQUALIZATION
ACCORDING TO THE MUSIC YOU ARE LISTENING TO :
EQ
*PASS CLASSIC JAZZ
ROCK POP
(*PASS MEANS EQUALIZER IS BY PASSED OR "OFF")
MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)
- PRESS (AND IMMEDIATELY RELEASE) THE BUTTON OR
BUTTON TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
BY 1-STEP AT A TIME.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH
STEP’S POSITION.
- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED
INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)
- PRESS AND HOLD (FOR 2 SECONDS) THE OR BUTTONS
TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
TO THE NEXT AVAILABLE RADIO STATION.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE
NEXT STATION THAT IS FOUND.
- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE
“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
NEXT BACK
NEXT BACK
RADIO MEMORY (STATION PRESET MEMORY STORAGE)
- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE
STORED INTO ONE OF THE MEMORY POSITION.
- PRESS BUTTON ONCE.
- PRESS OR TO SELECT DESIRED MEMORY POSITION. (THERE ARE
10 MEMORY POSITIONS FOR EACH RADIO BAND).
- PRESS BUTTON ONCE TO SAVE THE SELECTED STATION INTO THE
SELECTED MEMORY POSITION.
- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS OR , THE SAVED
RADIO-BAND WILL BE RECALLED.
- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO
THE SAME MEMORY POSITION.
PROGRAM
M+ M-
M+ M-
INSERTION AND REMOVAL OF DISCS
IMPORTANT: ALWAYS HOLD A CD BY IT'S EDGES. AVOID GETTING ANY FINGER-PRINTS,
SMUDGES OR DIRT ONTO THE SURFACE OF A DISC. IN CASE THIS HAPPENS,
USE A SPECIAL CD-CLEANING CLOTH OR CLEANING KIT TO REMOVE THE DIRT OR
SMUDGES.
PRESS THE STOP/DOOR OPEN BUTTON TO OPEN THE CD-DOOR. CAREFULLY
PLACE A COMPACT DISC (CD) ONTO THE TRAY IN THE CENTER POSITION,
WITH THE LABEL SIDE (PRINTED SIDE OF DISC) FACING UPWARDS.
GENTLY CLOSE THE CD-DOOR DOWNWADS UNTIL IT LOCKS FIRMLY IN
PLACE.THE CD-DISPLAY WILL SHOW THE TOTAL NUMBER OF
TRACKS ON THE DISC AFTER A FEW SECONDS. THE CD IS NOW READY TO
BE PLAYED. TO REMOVE A DISC, PRESS THE DOOR OPEN BUTTON WHEN
THE DISC IS STOPPED (NOT SPINNING). THE DOOR WILL OPEN UPWARDS
ALLOWING THE REMOVAL OF THE CD INSIDE.
NORMAL CD OPERATION
- PRESS BUTTON TO SWITCH ON THE UNIT.
- INSERT A CD AS DESCRIBED.
- PRESS BUTTON. THE DISK WILL START SPINNING & THE FIRST
SONG (TRACK) WILL START PLAYING. THE DISPLAY WILL INDICATE THE CURRENT
TRACK NO.
- AT ANY ANYTIME DURING PLAYBACK, PRESS THE BUTTON
TO PAUSE OPERATION OF THE UNIT. PRESS BUTTON TO RESUME
OPERATION AT THE SAME TRACK & POSITION.
- AT ANYTIME DURING PLAYBACK, PRESS THE BUTTON TO STOP OPERATION
OF THE SET. THIS WILL RESET THE SET TO THE FIRST TRACK (IF YOU PRESS
PLAY AFTER STOP, THE FIRST TRACK WILL ALWAYS START PLAYING).
- AT ANYTIME DURING PLAYBACK, PRESS AND RELEASE THE OR
BUTTONS TO SKIP FORWARD OR BACKWARDS BY ONE TRACK, AS DESIRED.
- ANY ANYTIME DURING PLAYBACK, PRESS AND HOLD THE OR
BUTTONS TO FAST-FORWARD (CUE) OR FAST-REVERSE (REVIEW) THE SPECIFIC
TRACK, WHICH IS CURRENTLY PLAYING.
POWER
PLAY
PLAY
PLAY
STOP
PROGRAM
NEXT BACK
NEXT BACK
E-10
