Haneco ESODO BOX 24M User manual

For more information
www.haneco.com.au
[phone]
For more information
www.haneco.com.au
[phone]
HANECO LIGHTING EMERGENCY LED EXIT BOX TYPE LIGHT
INSTALLATION GUIDE
ESODO BOX 24M
Thanks for choosing our ESODO BOX 24M EXIT products.
We strongly recommend that you read this manual carefully before installation.
Product Specications
Product Code Max power
consumption
when charging
IP Rating Input Rating Operating
Temperature
Electrical
Consumption
EM Time
ESOD-
O24M-BOX
3W IP20 220 – 240V AC
50/60Hz
0-45° Class II >2hr
Ceiling Mount
1. Switch-o main power
2. Unlock the mounting base by rotating the locker anticlockwise for 90 degrees.

For more information
www.haneco.com.au
[phone]
Cont.
3. Bring the main cable in from the knock-out in the middle top. Then mount the base on
desired surface.
4. Wire the tting as illustrated in the diagram below
4. Wire the tting as illustrated in the diagram below

For more information
www.haneco.com.au
[phone]
Cont.
5. Place the tting back
6. Test the installation in accordance with wiring rules and regulation, Switch on power.

For more information
www.haneco.com.au
[phone]
Wall Mount
1. Switch-o main power
2. Unlock the mounting base by rotating the locker anticlockwise for 90 degrees.
3. Knock out the cable entry in the middle at back and connect to the mains

For more information
www.haneco.com.au
[phone]
4. Mount the base on desired surface
5. Replace the tting and lock
Cont.

For more information
www.haneco.com.au
[phone]
Cont.
6. Test the installation in accordance with wiring rules and regulation, Switch on power.