Hannay Reels CR1600 SERIES User manual

Hannay Reels, Inc.
553 State Route 143, Westerlo, NY 12193
www.hannay.com
Email: [e-mail]
Phone [phone]
Toll Free 1-877-GO-REELS (467-3357)
Fax 1-800-REELING (733-5464)
Int’l Fax [phone]
TSB 2018.01.001
Making Cable Connections
on CR Series Reels
A󰀨ected Reels CR Reels
Time Required:
Priority: On Installation
Date Issued: January 2018
MAKE SURE TO FOLLOW ALL LOCAL/STATE/NATIONAL ELECTRICAL CODES
BE SURE TO SHUT OFF ALL INCOMING BREAKERS OR POWER SOURCES
LIQUID-TIGHT CONNECTIONS SHOULD BE USED AT ALL TIMES.
1 of 2 Form H-1801-TSB
PDF 1-18
CR1600 SERIES
CR REEL PARTS
1 Spool
2 Frame
3Collector Assembly
4 Collector Cover
5 Outlet Wire
6 Hub
7 Junction Box
8 Liquid Tight Conduit
9 Motor
10 Spring
NSCR SERIES
CR6600 SERIES
1
4
7
6
2
3
5
10
8
1
4
7
6
2
3
5
9
8
8
4
7
6
2
3
5
9
1

2 of 2 Form H-1801-TSB
PDF 1-18
1. Remove Collector Cover, Junction Box Cover (if present) and Drum Insert (if present).
2. Route wire into drum and through the hub. For reels with a drum insert the cable must rst
be routed through the grommet in the insert before going into the drum.
3. Attach wires to corresponding leads on collector ring using appropriate connectors. Verify
reel & cable do not bind on rotation.
4. Make corresponding in coming connection in the junction box (if present) or route incoming
wires to the back side of the collector plate.
5. Check wire continuity from input to output. Reinstall drum insert and attach cable to drum
using a cable clamp.
6. Reinstall collector cover and junction box cover.
7. Reconnect all power sources and wind cable onto spool.
7 a. For spring powered reels refer to TSB 2013-07-005 for installation instructions.
Actions Required:
Tools Required:
• Phillips Head Screw Driver
• Flat Head Screw Driver
• Crimping Tool
• 7/16” Socket with Ratchet & Extension (To Remove Collector Cover)
• Wire Puller
COLLECTOR ASSEMBLY
COLLECTOR ASSEMBLY PARTS
1 Slip Ring
2Brush Assembly
3 Liquid Light Conduit
4 Junction Box
5 Butt Splice
6 Outlet Wire
7 Inlet Wire
4
7
6
2
3
1
5