Harbour Ares User manual

Assembly Instructions for Ares
Parasol
www.harbourlifestyle.co.uk
If you have any questions or require additional support, please contact the team at
[email protected]. Alternatively you can contact us via telephone on 01223 626006.

I
J
B
A
D
E
F
C
G
H JI
2

step 1. step 2.
1. Assemble the base frame pieces (B) into an “X” as shown by
lining up their middle cutouts.
1. Lift the outer housing of the rotation component (D) to reveal the
mounting plate on its bottom.
3

x4
step 3.
1. Place the rotation component (C) on to the frame assembly (B). Align the four holes on the frame assembly to the inner set of holes on
the plate of the rotation component.
2. Thread an M8 bolt (F) from the top of the plate of the rotation component into the base. Tighten with #5 hex key (H). Repeat this step
for all four holes.
4

Y .
screw the cap back in place. You may notice some leaking when the component is not in is natural position which should stop when it is upright.
3. Place the base assembly where you intend to place your umbrella, then put the four base reservoirs on top of the base assembly as illustrated.
step 4.
1
2
5

step 5. step 6.
I
6

step 7.
1. Push the crank handle (E) over the crank nut on the umbrella frame.
2. Use the #2.5 hex key (J) to tighten the crank handle into place.
1
2
7

opening and tilting
1. Press the handle button in fully.
2. While the button is fully pressed, slide the handle up the frame to
extend the canopy arm. Release the button at the desired position.
3. Crank the handle to open/close the canopy.
4. To adjust tilt, press the handle button then slide the handle up/down
the frame until the desired angle is achieved.
1
2
3
8

rotating
Use caution when rotating an open umbrella. Ensure ample clearance prior to rotating.
1. Step on the rotation pedal to unlock the umbrella from the base.
2. Carefully rotate the umbrella while checking for obstructions.
3. Release the rotation pedal to lock the umbrella into place.
1
2
9

10
led

11
turn on / off
SUNSHINE
1